-
1
SARS-CoV-2 infection triggers more potent antibody-dependent cellular cytotoxicity (ADCC) responses than mRNA-, vector-, and inactivated virus-based COVID-19 vaccines
Published 2024“…Here, we investigated ADCC activity in convalescent sera from infected patients with wild-type (WT) severe acute respiratory syndrome coronavirus-2 (SARS-CoV-2) or omicron variant compared with three coronavirus disease 2019 (COVID-19) vaccine platforms and postvaccination breakthrough infection (BTI). …”
Get full text
Get full text
Get full text
-
2
Modification of Pd/CeO2 catalyst by Atomic Layer Deposition of ZrO2
Published 2016“…Methane-oxidation rates in 0.5% CH4 and 5% O2 were slightly lower on the ZrO2-covered catalyst when both materials were calcined at 673 K but the activity of the ZrO2-modified catalyst did not decrease with catalyst calcination temperature. …”
Get full text
Get full text
-
3
Reactive Absorption of CO2 Using Ethylaminoethanol Promoted Aqueous Potassium Carbonate Solvent
Published 2016“…The H_(CO2) was observed to be decreased by 5 and 31% due to the increase in the EAE concentration from 0.6 to 2 kmol/m3 and reaction temperature from 303 to 318 K, respectively. …”
Get full text
Get full text
-
4
-
5
Structural and mechanical characterization of stir cast Al–Al2O3–TiO2 hybrid metal matrix composites
Published 2020“…Aluminium matrix reinforced with aluminium oxide?titanium oxide (2.5, 5.0, 7.5 and 10 wt.%) in equal proportion were prepared by stir casting. …”
Get full text
Get full text
-
6
Role of TiO2 and carbon nanotubes on polyethylene, and effect of accelerated weathering on photo oxidation and mechanical properties
Published 2019“…Addition of CNTs had negligible effect on the tensile strength but it kept the same approximate value of the original before the accelerated weathering (e.g., 23.2 MPa for 1 wt% of CNTs). CNTs also protected the samples even with the presence of TONPs because of the absorbance and antioxidants effects. …”
Get full text
Get full text
-
7
Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles
Published 2021“…Electrospinning technique was employed to fabricate composite nanofibers/nanoparticles of sulfonated polyether ether ketone, polyvinylpyrrolidone, and ruthenium oxide (sPEEK/PVP/RuO2). The samples were synthesized with different concentrations of hydrous ruthenium chloride of 2 wt%, 5 wt%, and 10 wt%, and then annealed at a temperature of 300 �C for 4 h to form the ruthenium oxide nanoparticles. …”
Get full text
Get full text
-
8
Biodegradable polysaccharide grafted polyacrylamide inhibitor for corrosion in CO2- saturated saline solution
Published 2023“…Electrochemical tests of Tafel and AC impedance, were used to determine the corrosion rate of carbon steel (C-steel) and protection efficiency in CO2-saturated 3.5 wt% NaCl solution. The surface morphology was characterized using FESEM coupled with EDX. …”
Get full text
Get full text
-
9
Effect of concentration of DOC loaded TiO 2 nanotubes on the corrosion behavior of smart coatings
Published 2019“…Various contents of the encapsulated TiO2 nanotubes (1, 3 and 5 wt%) were thoroughly dispersed into the epoxy matrix and the resulting composites were then applied on a cleaned steel substrate using doctor blade technique to develop smart coatings. …”
Get full text
Get full text
-
10
Tailoring electrocatalytic properties of Pt nanoparticles grown on Ti3C2Tx MXene surface
Published 2019“…Composites containing 14 wt% Pt showed HER with an onset potential of −75.9 mV and a current density of −10 mA cm−2 achieved at −226 mV. …”
Get full text
Get full text
Get full text
-
11
Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites
Published 2020“…The aim of the present study is to investigate the structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites. Copper matrix composites with Al2O3–graphite reinforcement (0.5-0.5, 1.0-1.0, 1.5-1.5 and 2.0-2.0 wt%) were prepared by stir casting process. …”
Get full text
Get full text
-
12
Synthesis and characterisation of Co2+-incorporated ZnO nanoparticles prepared through a sol-gel method
Published 2016“…The band gap of the Co2+-doped ZnO samples decreased from 3.19 to 2.66 eV as the content of dopant Co2+ increased from 0.0 to 1.0 wt.%. …”
Get full text
Get full text
-
13
Phase, microstructure and tensile strength of Al–Al2O3–C hybrid metal matrix composites
Published 2020“…Aluminium matrix reinforced with Al2O3–carbon (2.5, 5, 7.5 and 10 wt.%) in equal proportion was prepared by stir casting. …”
Get full text
Get full text
-
14
Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites
Published 2021“…Al2O3-SiC (2.5 wt.%, 5.0 wt.%, 7.5 wt.% and 10.0 wt.%) in relative and symmetrical proportion. …”
Get full text
Get full text
-
15
Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures
Published 2022“…The properties of the prepared MMCs were found to be dependent on the reinforcements content present in the MMCs. ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text
-
16
-
17
ELECTRODE SUSPENSION FOR AQUEOUS SODIUM FLOW BATTERY
Published 2022“…At 1.5 wt% KB, the anolytes could tolerate high load (25 wt%) of NTO without severe rise in the rigidity and conductivity under static and flow modes. …”
Get full text
-
18
-
19
Microstructure, wear and corrosion characteristics of Cu matrix reinforced SiC–graphite hybrid composites
Published 2019“…Copper matrix composites with SiC-graphite reinforcement (0, 2.5,5, 7.5 and 10 wt.%) were prepared by stir casting process. …”
Get full text
Get full text
-
20
Thermally conductive polyethylene/expanded graphite composites as heat transfer surface: Mechanical, thermo-physical and surface behavior
Published 2020“…Moreover, the surface wettability of the HDPE/EG composite was enhanced by corona and RF plasma treatment as demonstrated by the increase in surface free energy from 28.5 mJ/m2 for untreated HDPE/EG to 55.5 and 54.5 mJ/m2 for HDPE/EG treated by corona and RF plasma, respectively. …”
Get full text
Get full text
