Spectral and Structural Properties of High-Quality Reduced Graphene Oxide Produced via a Simple Approach Using Tetraethylenepentamine by Alkhouzaam A.

“…The replacement of the oxygenated groups increased the carbon/oxygen (C/O) ratio of GO by approximately 60%, suggesting a good reduction degree. …”
Get full text
Get full text
Get full text

Performance assessment of inductive power transfer for railway applications by Almuhannadi, D.

“…The practical implementation has been conducted at a rated voltage of 100V DC at 50kHz and input power of 80W. …”
Get full text
Get full text

Development of Semitransparent UV Photodetector Based on PTB7-Th:PCBM Composite Using the Cost-effective Fabrication Method by Riaz, Muhammad

“…After a comprehensive analysis under specific UV strength and frequency, a considerable increase in capacitance and a significant decrease in impedance were observed. …”
Get full text
Get full text
Get full text

The spectral and morphological studies of the conductive polyaniline thin film derivatives by the in situ copolymerization by Waware, Umesh S.

“…The blue shift in the band indicates that there is a decrease in the extent of conjugation system along the copolymer. …”
Get full text
Get full text

Partial characterization Of an alkalophilic extracellular Crude pectinases from a bacillus Polymyxa strain by Al Rajabi, Ihab. I. [ايهاب الرجبي وعادل محاسنه]

“…The optimum pH and optimum temperature for pectin lyase activity were 8.5 and 30°C, respectively, while for pectate lyase the optima were 9 and 30°C repectively. …”
Get full text

Influence of the heteroatom on the optoelectronic properties and transistor performance of soluble thiophene-, selenophene- and tellurophene-vinylene copolymers by Al-Hashimi, Mohammed

Get full text
Get full text

A robust experimental-based artificial neural network approach for photovoltaic maximum power point identification considering electrical, thermal and meteorological impact by Gowid, Samer

Get full text
Get full text
Get full text

Assessment of SnO2 nanoparticles' impact on the growth of Picochlorum maculatum algae by Bounnit, Touria

“…To determine the effect of SnO2 nanoparticles on Picochlorum maculatum - isolated from a Qatar marine environment, algal growth media are amended with different nanoparticle concentrations (1, 5, 25, 50, and 100 mg L−1) and the culture was observed for 72 h. …”
Get full text
Get full text
Get full text

Assessment of Dapagliflozin Effectiveness as Add-on Therapy for the Treatment of Type 2 Diabetes Mellitus in a Qatari Population by Al AdAwi R.M.

“…Administration of dapagliflozin as an add-on therapy was found to decrease HbA1c significantly by 0.8 percentage point after 6 months (P = 0.006) and by 1.5 percentage point after 12 months (P = 0.062). …”
Get full text
Get full text

Effect Of Gossypol, Apogossypol And Gossypolone On Fatty Acids Pattern Of Lipid Fractions In Rat Serum And Seminal Fluid by El sharaky, A. S. [احمد صبحي الشراكي]

“…While in the free fatty acids fraction, palmitic acid (C16:0) content was significantly decreased, meanwhile significant increase of polyunsaturated fatty acid (C22:5) with apogossypol and gossypolone treatment. …”
Get full text

Enhanced photovoltaic performance with co-sensitization of a ruthenium(ii) sensitizer and an organic dye in dye-sensitized solar cells by Mehmood, Umer

Get full text
Get full text

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study by Hamza A.

“…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …”
Get full text
Get full text
Get full text

Novel fluorinated surfactants for enhanced oil recovery in carbonate reservoirs by Al-Amodi, Adel O.

“…Core flooding experiments showed 42 % additional oil recovery using 2.5 g/L (2500 ppm) HPAM and 0.001 g/g (0.1 mass%) amphoteric surfactant at 90 °C.…”
Get full text
Get full text

Short-term greenhouse emission lowering effect of biochars from solid organic municipal wastes by Rehrah D.

“…Two biochars produced from mixed materials at 300–500 °C for 2 h and used at 0.5–1% application rate performed the best in enhancing soil fertility parameters. …”
Get full text
Get full text

Numerical evaluation of the thermal performance of a near-surface earth-to-air heat exchanger with short-grass ground cover: A parametric study by Pakari, Ali

“…By increasing the tube wall thickness from 1 to 10 mm, the outlet temperature for an aluminum tube remained unchanged, while for PE and PVC tubes, the outlet temperature increased by about 1.1 and 2.2 °C, respectively. By increasing the soil thermal conductivity from 1 to 5 W m−1 K−1 the outlet temperature decreased by about 4.4 °C.…”
Get full text
Get full text

Enhanced quality factor of polyvinyl formal (PVF) based nanocomposites filled with zinc oxide and carbon black nanoparticles for wireless sensing applications by Mohanapriya, M.K.

“…The incorporation of ZnO at 10% decreases Q-factor to 36.1. Incorporation of CBNP at 5% and ZnO at 5% further reduces the Q-factor to 13.7. …”
Get full text
Get full text

Epidemiology of herpes simplex virus type 2 in sub-Saharan Africa: Systematic review, meta-analyses, and meta-regressions by Harfouche, Manale

“…Pooled HSV-2 proportion in genital ulcer disease was 50.7% (95% CI: 44.7–56.8%) and in genital herpes it was 97.3% (95% CI: 84.4–100%). Interpretation: Seroprevalence is declining by 2% per year, but a third of the population is infected. …”
Get full text
Get full text
Get full text

Impact of pharmacist-involved collaborative care on diabetes management in a primary healthcare setting using real-world data by Abdulrhim, Sara

“…Results After 17 months of follow-up, pharmacist-involved collaborative care compared to usual care resulted in a significant decrease in HbA1c (6.8 ± 1.2% vs. 7.1 ± 1.3%, p < 0.01). …”
Get full text
Get full text

Investigation of optimal charging locations for electric vehicles in Istanbul by Atilgan, B.

Get full text
Get full text

Understanding the False Positive of Modified Martensitic Steels in Sweet & Sour Service Conditions Using a Point Defect Model Perspective by Martinez, Alan

“…Electrochemical tests were performed using a 1L autoclave holding 35 bar of CO2 gas with and without H2S at temperatures varied from 25 °C to 150 °C in salt brine solutions with a pH of 3.5. …”
Get full text