Modeling the influence of daily temperature and precipitation extreme indices on vegetation dynamics in Katsina State using statistical downscaling model (SDM) by Mohammad, Hadi Ahmad

“…Tmax and Tmin were projected under low emissions at 20.1 0C and 14.25 0C (RCP2.6), 20.13 °C and 14.26 0C (RCP4.5), and 20.15 0C and 14.27 0C (RCP8.5) respectively. …”
Get full text
Get full text
Get full text

Influence of natural gas composition on adsorption in calcite Nanopores: A DFT study by Elbashier E.

“…The nanopores absorbed up to 28 and 24 molecules of CH4 and CO2, respectively, and the adsorption energy decreased to −0.0062 and −0.0075 eV/Å2 for each. Although the nanopore was filled spatially by the molecules, its surface still has an affinity to absorb more gas molecules energetically. …”
Get full text
Get full text
Get full text

INVESTIGATING THE MOLECULAR MECHANISMS UNDERLYING THE ANTI-CANCER ACTIVITIES OF DIOSMETIN IN COLORECTAL CANCER CELLS: AN IN VITRO STUDY by AHMED, SABAH NISAR

Get full text

VacoNet: Variable and connected architecture for data center networks by Chkirbene, Zina

“…In addition, VacoNet can reach even 50% in infrastructure cost reduction and the power consumption will be decreased with more than 50000 watt compared to all the previous architectures. …”
Get full text
Get full text

Compressive And Tensile Strength Of Concrete Loaded And Soaked In Crude Oil by Abdul Ahad, Ramzi B.

“…Results show that the rate of crude oil absorption is high at early stages of soaking, but this rate decreases with time. There is a reduction in the absorption by 30 to 40 percent of ultimate strength in specimens exposed to instantaneous loading as compared with unloaded specimens. …”
Get full text

Enhanced performance of nano-sized SiC reinforced Al metal matrix nanocomposites synthesized through microwave sintering and hot extrusion techniques by Reddy, M. Penchal

“…In the present study, nano-sized SiC (0, 0.3, 0.5, 1.0 and 1.5 vol%) reinforced aluminum (Al) metal matrix composites were fabricated by microwave sintering and hot extrusion techniques. …”
Get full text
Get full text

An experimental study on achieving even-frosting for an air source heat pump using a novel dual-fan outdoor coil by Bai, Xiaoxia

“…The experimental results demonstrated that when using the novel dual-fan outdoor coil in Cases 3, 4 and 7, the heating/frosting duration was lengthened by 23.6%, 34.5% and 46.4%, and the averaged output heating capacity () was increased by 5.5%, 9.5% and 9.6 %, and averaged COP () by 6.7%, 10.5% and 11.1% respectively, and the defrosting frequency was decreased by 33.3% in Case 7,when compared to using the traditional single-fan outdoor coil. …”
Get full text
Get full text

Detailed organic characterization of process water to evaluate reverse osmosis membrane fouling in industrial wastewater treatment by Minier-Matar, Joel

“…After ACF treatment, the hydrophobic organics decreased to 0.65 mg/L, revealing that the ACF is removing >50 % of hydrophobic organics which are likely responsible for membrane fouling. …”
Get full text
Get full text
Get full text

Improved properties of Al-Si3N4 nanocomposites fabricated through a microwave sintering and hot extrusion process by Matli, Penchal Reddy

“…In this study, nano-sized Si3N4 (0, 0.5, 1.0 and 1.5 vol%)/Al composites were fabricated using a powder metallurgy method involving microwave sintering technique followed by hot extrusion. …”
Get full text
Get full text

Preliminary Observations On The Relative Growth And Production Of Tilapia Species Cultured In Cages At Three Stocking Densities by Al Zahaby, A. S. [الاحمدي الذهبي]

Get full text

Antimicrobial activity of amphiphilic nanomicelles loaded with curcumin against Pseudomonas aeruginosa alone and activated by blue laser light by Rupel, Katia

“…Among the three sublethal blue laser (λ 445 nm) protocols tested, the ones characterized by a fluence of 18 and 30 J/cm2 further decreased the antimicrobial concentration to 50 nM. …”
Get full text
Get full text

Simulation-Based Parametric Study for the Hybrid Superplastic Forming of AZ31 by Al-Abtaha, Fatima Ghassan

Get full text
Get full text

Towards the higher solubility and thermal stability of poly(aniline-co-m-bromoaniline) by WawareU.S.

Get full text
Get full text

Pharmacy preceptor judgments of student performance and behavior during experiential training by WilburK.

Get full text

Temperature sensor based on composite film of vanadium complex (VO2(3-fl)) and CNT by Karimov, Kh S.

Get full text
Get full text
Get full text

Thermal and mechanical properties of PP/HDPE/wood powder and MAPP/HDPE/wood powder polymer blend composites. by Dikobe, D.G.

Get full text
Get full text

Production Of Size-selected Copper Nanoclusters For Petroleum Refinery Applications by Ayesh, Ahmad

Get full text
Get full text

Dynamic Salmonella Enteritidis biofilms development under different flow conditions and their removal using nanoencapsulated thymol by Yammine, Jina

“…Enteritidis biofilms displayed 5.96, 6.28 and 6.80 log CFU cm−2 under 0.006 cm s−1, 0.045 cm s−1, and 0.087 cm s−1 flow velocities, respectively. …”
Get full text
Get full text
Get full text

Effect of water absorption on the mechanical properties of long date palm leaf fiber reinforced epoxy composites by Mahdi, E.

“…The tensile/flexural results showed that water absorption decreased the specific ultimate strength and specific modulus by 14.8/14.5% and 40.1/17.8% respectively. …”
Get full text
Get full text
Get full text

Carbon nanotube effect on the ductility, flexural strength, and permeability of concrete by Mohsen, Mohamed O.

Get full text
Get full text