Structural performance and moment redistribution of basalt FRC continuous beams reinforced with basalt FRP bars by Abushanab, Abdelrahman

“…This study investigated the structural performance and moment redistribution of basalt fiber reinforced concrete (BFRC) continuous beams reinforced with basalt fiber reinforced polymers (BFRP) bars. A total of 10 reinforced concrete (RC) continuous beams over two equal spans of 1800 mm were tested under five-point loading until failure. …”
Get full text
Get full text

Simulation and Optimization of an LNG Plant Cold Section by Katebah, Mary Anna

“…Heavy hydrocarbons, primarily condensate (C5+) leaving the fractionation unit, can be either sold or sent to a close by refinery for further processing. …”
Get full text
Get full text

Nanoclay compatibilization of phase separated polysulfone/polyimide films for oxygen barrier by Ammar, Ali

“…Thermal decomposition (TGA) measurements of PSF/PI films showed a decrease in thermal stability upon adding C30B due to its surfactant modification, while film mechanical tensile modulus properties improved slightly by adding low concentration of C30B (~ 1 mass%), but higher nanoclay loading decreased tensile strength and elongation at break. …”
Get full text
Get full text

Global, regional, and national burden of HIV/AIDS, 1990–2021, and forecasts to 2050, for 204 countries and territories: the Global Burden of Disease Study 2021 by Austin, Carter

“…In 2021, sub-Saharan Africa had the highest PUV of 999·9 (857·4–1154·2) per 100 000 population, but this was a 64·5% (58·8–69·4) reduction in PUV from 2003 to 2021. …”
Get full text
Get full text
Get full text

Financial Intermediaries and Capital Market Development in Nigeria by Ilo, Bamidele M.

“…The result revealed that in the long run, credit to private sector and money supply will lead to an increase in capital market development while banks total savings and government expenditure results to a decrease in capital market development in the long run. …”
Get full text
Get full text

Adhesive properties of polyester treated by cold plasma in oxygen and nitrogen atmospheres by Novak, I.

Get full text
Get full text

Antibacterial Properties of Polysulfone Membranes Blended with Arabic Gum. by Sabri, Souhir

Get full text
Get full text

Repositioning for pressure injury prevention in adults. by Gillespie, Brigid M

“…We assessed the certainty of the evidence using GRADE. We identified five additional trials and one economic substudy in this update, resulting in the inclusion of a total of eight trials involving 3941 participants from acute and long-term care settings and two economic substudies in the review. …”
Get full text
Get full text

Effects of Climate and Atmospheric Nitrogen Deposition on Early to Mid-Term Stage Litter Decomposition Across Biomes by Kwon, Taeoh

“…In contrast, expected changes in atmospheric N deposition will decrease the mid-term mass loss of high-quality litter by 1.4-2.2% and that of low-quality litter by 0.9-1.5% in the temperate biome. …”
Get full text
Get full text
Get full text

Forecast of the outbreak of COVID-19 using artificial neural network: Case study Qatar, Spain, and Italy by Shawaqfah M.

“…The first wave of the pandemic outbreak of the novel Coronavirus (SARS-CoV-2) began in September 2019 and continued to March 2020. …”
Get full text
Get full text

Gas Driven Fracture during Gas Production using HeleShaw Cell by Al-Raoush, Riyadh

“…Following saturation, CO2 is applied to the cell at a constant pressure (2 kPa, 5 kPa, and 10 kPa). …”
Get full text
Get full text

Tailoring electrocatalytic properties of Pt nanoparticles grown on Ti3C2Tx MXene surface by Filip, Jaroslav

“…Composites containing 14 wt% Pt showed HER with an onset potential of −75.9 mV and a current density of −10 mA cm−2 achieved at −226 mV. …”
Get full text
Get full text
Get full text

Nonlinear stochastic modeling for optimal dispatch of distributed energy resources in active distribution grids including reactive power by Mehrjerdi, Hasan

Get full text
Get full text

The status of forward osmosis technology implementation by Awad, Abdelrahman M.

Get full text
Get full text

The Structure of the Free Volume in Poly(styrene-co-acrylonitrile) from Positron Lifetime and Pressure Volume Temperature (PVT) Experiments by Dlubek, Gunter

“…The mean hole volume, vh, varies in PS between 105 Å3 (27 °C) and 220 Å3 (190 °C), and shows a systematic decrease with increasing AN content, at Tg from 121 Å3 for PS to 102 (±2) Å3 for SAN50. …”
Get full text
Get full text

Structural analysis of missense mutations in galactokinase 1 (GALK1) leading to galactosemia type-2. by P, Sneha

“…Molecular docking analysis revealed a decrease in interaction between the protein and ATP in all the 3 mutations, and molecular dynamic simulations of 50 ns showed a loss of stability and compactness in the mutant proteins. …”
Get full text
Get full text

Electric vehicles charging management using deep reinforcement learning considering vehicle-to-grid operation and battery degradation by Mostafa M., Shibl

“…In this paper, a deep RL-based EVs charging management solution is presented, while considering fast charging, conventional charging and V2G operation, in order to satisfy the requirements of the user and the utility. …”
Get full text
Get full text
Get full text

Integrated planning of spare parts and service engineers with partial backlogging by Rahimi-Ghahroodi, S.

“…In a numerical study, we show that for problems with more than five types of spare parts it is preferable to use approximate evaluations as they become significantly faster than exact evaluation. …”
Get full text
Get full text

Understanding the progress and challenges in the fields of thermo-catalysis and electro-catalysis for the CO2 conversion to fuels by Yadav, V. S. K.

Get full text
Get full text

Cold Plasma as Effective Tool for Aluminum Surface Cleaning by Popelka, Anton

“…In the final step, two layers of foils are wounded together and rolling oil is sprayed between the two layers and the -twin foil- is rolled down. A continuous amorphous oxide layer is formed immediately after rolling process due to the reaction of oxygen and air humidity and therefore new metal surface is produced [5]. …”
Get full text
Get full text