يعرض 1,061 - 1,080 نتائج من 1,761 نتيجة بحث عن '(( 5 points decrease ) OR ( 10 ((((peter decrease) OR (nn decrease))) OR (a decrease)) ))', وقت الاستعلام: 0.21s تنقيح النتائج
  1. 1061
  2. 1062

    Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating حسب Cabibbo, M.

    منشور في 2015
    "…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …"
    احصل على النص الكامل
  3. 1063
  4. 1064

    Pd nanocrystals encapsulated in MOF-derived Ni/N-doped hollow carbon nanosheets for efficient thermal CO oxidation: unveiling the effect of porosity حسب Ipadeola, Adewale K.

    منشور في 2023
    "…The obtained Pd/Ni-MOF-HNC possesses hollow carbon sheets with a great surface area (153.05 m2 g−1), pore volume (0.12 cm3 g−1), rich Pd/Ni-Nx active sites, Ni-metal defects, rich N-content (7.53 at%), mixed Pd/Ni-oxide phases, and uniformly distributed ultra-small Pd nanocrystals (7.03 ± 1.10 nm); meanwhile, Pd/Ni-MOF-NC formed without etching had no porosity and less Ni-metal defects. …"
    احصل على النص الكامل
    احصل على النص الكامل
    احصل على النص الكامل
  5. 1065
  6. 1066

    Origanum Syriacum Inhibits Proliferation, Migration, Invasion and Induces Differentiation of Human Aortic Smooth Muscle Cells حسب AlDisi, Sara

    منشور في 2014
    "…Cardiovascular diseases (CVDs) are still the number one cause of morbidity and mortality both in Qatar and worldwide. A major risk factor of CVDs is atherosclerosis, the hardening of blood vessels caused by decreased diameter and formation of plaque. …"
    احصل على النص الكامل
    احصل على النص الكامل
  7. 1067
  8. 1068
  9. 1069
  10. 1070
  11. 1071

    Gas Driven Fracture during Gas Production using HeleShaw Cell حسب Al-Raoush, Riyadh

    منشور في 2018
    "…Methane hydrate is considered a potential energy source, with worldwide reserves on the order of 500-10,000 Gt of carbon. …"
    احصل على النص الكامل
    احصل على النص الكامل
  12. 1072
  13. 1073

    Thermal and mechanical characterization of injection moulded high density polyethylene/paraffin wax blends as phase change materials حسب Sotomayor, M.E.

    منشور في 2014
    "…Elongation at break decreased as paraffin wax content increased, and Young's modulus decreased with wax content but in the case of blends with a 30vol. % of wax and more, brittle rupture occurred and no yield point was observed.…"
    احصل على النص الكامل
    احصل على النص الكامل
  14. 1074

    Numerical investigation of steady air injection flow to control rotating stall in centrifugal compressors حسب Halawa, Taher

    منشور في 2014
    "…Numerical model was built to simulate high speed transonic centrifugal compressor working at an operating point close to surge. Air was injected at 12 locations at the vaneless region between the impeller and the diffuser at shroud surface with 5 different injection angles and 3 different injection mass flow rates. …"
    احصل على النص الكامل
    احصل على النص الكامل
    احصل على النص الكامل
  15. 1075

    Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures حسب Mittal, Prateek

    منشور في 2022
    "…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.01.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …"
    احصل على النص الكامل
    احصل على النص الكامل
    احصل على النص الكامل
  16. 1076
  17. 1077
  18. 1078

    Hydrogen Production via Ethanol Decomposition over Bimetallic Catalyst حسب Ashok, Anchu

    منشور في 2016
    "…SEM of as-synthesized nanoparticles of cobalt oxide at different molar ratios from 0.5 to 2.5 in SCS mode shows the nanoparticles of high porosity that are randomly distributes as well as agglomerated. …"
    احصل على النص الكامل
    احصل على النص الكامل
  19. 1079
  20. 1080