Corrosion behavior of API X100 steel material in a hydrogen sulfide environment by Okonkwo, Paul C.

“…The results indicate that the corrosion rate of API X100 steel decreases with increasing H2S bubbling time due to the increase in H2S concentration in 3.5% NaCl solutions. …”
Get full text
Get full text

Opportunities, challenges and trade-offs with decreasing avoidable food waste in the UK by Patel, Shivalee

Get full text
Get full text
Get full text

Corrosion inhibition of API X120 steel in a highly aggressive medium using stearamidopropyl dimethylamine by Radwan, A.Bahgat

“…The overall results showed that SAPDA significantly decreased the corrosion rate of API X120 steel with an inhibition efficiency of approximately 99% at an inhibitor concentration of 136 μmol L− 1. …”
Get full text
Get full text

Electrochemical and thermodynamic study on the corrosion performance of API X120 steel in 3.5% NaCl solution by Shahzad, Khuram

“…The overall results revealed that PEI significantly decreases the corrosion rate of API X120 steel with inhibition efficiency of 94% at a concentration of 100 μmol L−1. …”
Get full text
Get full text
Get full text

Caprylamidopropyl Betaine as a Highly Efficient eco-friendly Corrosion Inhibitor for API X120 Steel in 1 M H2SO4 by Foudaa, Abd El Aziz S.

“…The overall results displayed that the corrosion rate of API X120 steel was significantly lowered with improving the temperature. …”
Get full text
Get full text
Get full text

Corrosion behavior of API-X120 carbon steel alloy in a GTL F-T process water environment at low COD concentration by Ewis, Dina

“…The effect of temperature, time and rotation speed of FT-GTL process water on the corrosion rate of API X-120 carbon steel was investigated. Electrochemical impedance spectroscopy and potentiodynamic polarization techniques were used to determine the carbon steel corrosion rate under temperatures ranging from 293 to 323 K and rotation speed of 0, 500, 1000, 2000 rpm when the immersion time was 0.5, 1, and 2 h. …”
Get full text
Get full text

Turning point in COVID-19 severity and fatality during the pandemic: a national cohort study in Qatar by Chemaitelly, Hiam

Get full text
Get full text

A robust experimental-based artificial neural network approach for photovoltaic maximum power point identification considering electrical, thermal and meteorological impact by Gowid, Samer

“…The results showed a decrease in the MSE of Vmp by 74.3% (from 1.6 V to 0.411 V), and in the MSE of Imp by 95% (from 4.4e−6 A to 2.16e−7 A), respectively. …”
Get full text
Get full text
Get full text

Effects of superelastic nano-NiTi additions on electroless Ni –P coating properties under bending by MacLean M.

Get full text
Get full text

Blue photobiomodulation LED therapy impacts SARS-CoV-2 by limiting its replication in Vero cells by Zupin, L.

Get full text
Get full text
Get full text

Comprehensive thermoeconomic, exergoeconomic, and optimization analyses of direct oxy-combustion supercritical CO2 intercooled and reheated cycles under design and off-design condi... by Al-Ammari, Wahib A.

“…This study presents comprehensive energetic, exergetic, exergoeconomic, and economic (4E) performance analyses for four direct oxy-combustion (DOC) supercritical carbon dioxide (sCO2) power cycles at design, off-design, and part-load conditions. …”
Get full text
Get full text
Get full text

Thermal and mechanical characterization of injection moulded high density polyethylene/paraffin wax blends as phase change materials by Sotomayor, M.E.

Get full text
Get full text

Driver Drowsiness Detection Study using Heart Rate Variability analysis in Virtual Reality Environment by Chowdhury, Muhammad E.H.

Get full text
Get full text

Development of pH-Controlled Aluminum-Based Polymeric Gel for Conformance Control in Sour Gas Reservoirs by Shamlooh M.

“…Moreover, the system showed good stability in saline conditions with NaCl concentration of up to 50,000 ppm. …”
Get full text
Get full text
Get full text

Bioactive PCL matrices with a range of structural & rheological properties by Douglas, P.

“…Bulk PCL and various blends with 5 and 25% polyethylene glycol (PEG, a plasticiser and pore former) and 5% nalidixic acid (NA, the API) were processed using extrusion and pressed into plaques. …”
Get full text
Get full text

Optimization of performance and emission characteristics of CI engine fueled with Jatropha biodiesel produced using a heterogeneous catalyst (CaO) by Singh, A.

“…The optimum performance and emission characteristics (BP, BTHE, HC and NOx) are found to be 2.258 KW, 29.05%, 6.31 ppm, and 159.5 ppm respectively. The performance of B20 fueled engine was almost comparable to that of diesel fuel. …”
Get full text
Get full text

The Separation of Emulsified Water/Oil Mixtures through Adsorption on Plasma-Treated Polyethylene Powder by Abdulkareem, Asma

“…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …”
Get full text
Get full text

The separation of emulsified water/oil mixtures through adsorption on plasma-treated polyethylene powder by Abdulkareem A.

“…The efficiency of the plasma-treated LDPE powder in oil removal was found to be dependent on the initial oil concentration. It decreased from 96.7% to 79.5% as the initial oil concentration increased from 75 ppm to 200 ppm. …”
Get full text
Get full text

Novel fluorinated surfactants for enhanced oil recovery in carbonate reservoirs by Al-Amodi, Adel O.

“…Core flooding experiments showed 42 % additional oil recovery using 2.5 g/L (2500 ppm) HPAM and 0.001 g/g (0.1 mass%) amphoteric surfactant at 90 °C.…”
Get full text
Get full text

Assessment of Dapagliflozin Effectiveness as Add-on Therapy for the Treatment of Type 2 Diabetes Mellitus in a Qatari Population by Al AdAwi R.M.

“…Administration of dapagliflozin as an add-on therapy was found to decrease HbA1c significantly by 0.8 percentage point after 6 months (P = 0.006) and by 1.5 percentage point after 12 months (P = 0.062). …”
Get full text
Get full text