Search alternatives:
_ thin » _ things (Expand Search)
Showing 1 - 20 results of 495 for search '(( 50 ((_ decrease) OR (mean decrease)) ) OR ((( _ thin decrease ) OR ( 25 mg decrease ))))*', query time: 0.15s Refine Results
  1. 1

    Experimental analysis of additively manufactured thin-walled heat-treated circular tubes with slits using AlSi10Mg alloy by quasi-static axial crushing test by Mohamed A.S.

    Published 2019
    “…In this study, additively manufactured aluminum thin-walled tubes with different slit dimensions are proposed to improve energy absorption efficiency. …”
    Get full text
    Get full text
  2. 2

    DC conductivity and Seebeck coefficient of nonstoichiometric MgCuZn ferrites by Madhuri, W.

    Published 2017
    “…Nonstoichiometric series of Mg0.5-xCuxZn0.5Fe1.9O4-? where x = 0.0, 0.1, 0.15, 0.2 and 0.25 has been synthesized by conventional solid state reaction route. …”
    Get full text
    Get full text
  3. 3

    Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

    Published 2015
    “…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
    Get full text
  4. 4

    Biocorrosion behavior of biodegradable nanocomposite fibers coated layer-by-layer on AM50 magnesium implant by Abdal-hay, Abdalla

    Published 2016
    “…The corrosion performance of coated and uncoated coupon samples was investigated by means of electrochemical measurements. The results showed that the AJS 3D membrane fiber layers, particularly the hybrid membrane layers containing a small amount of nHA (3wt.%), induce a higher biocorrosion resistance and effectively decrease the initial degradation rate compared with the neat AM50 coupon samples. …”
    Get full text
    Get full text
  5. 5

    The mitochondrial-related effect of the 905 nm photobiomodulation therapy on 50B11 sensory neurons by Zupin, Luisa

    Published 2023
    “…In this study, a possible molecular mechanism of the 905 nm PBMT (0.25 W/cm2; 3, 6, 12, and 18 J/cm2, 5 Hz) analgesic effect was tested on 50B11 cells, by investigating its impact on mitochondria. …”
    Get full text
    Get full text
    Get full text
  6. 6

    The spectral and morphological studies of the conductive polyaniline thin film derivatives by the in situ copolymerization by Waware, Umesh S.

    Published 2017
    “…Thin film of copolymers of poly(aniline-co-2-iodoaniline) are obtained by in situ copolymerization of aniline and 2-iodoaniline as the startup monomers by chemical oxidation upon varying the molar feed to ratio of monomers to procure the different compositions. …”
    Get full text
    Get full text
  7. 7

    High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling by Cabibbo, Marcello

    Published 2014
    “…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
    Get full text
    Get full text
  8. 8

    Binding energy, structural, and dielectric properties of thin film of poly(aniline-co-m-fluoroaniline) by Waware, Umesh S.

    Published 2018
    “…The permittivity of copolymer PA-co-m-FA50 has a higher value than polyaniline in the high-frequency regime and decreases with the increase of frequency. …”
    Get full text
    Get full text
  9. 9
  10. 10
  11. 11

    Impact of trace noble metals on the catalytic performance of LaNiMgO towards methane dry reforming by Mohamed, Assem T.

    Published 2024
    “…On the other hand, at the same time-on-stream LaNiMgO-Rh lost 0.3 and 0.7 % of its maximum CO2 and CH4 conversions, respectively.In durability measurements, and after 140h LaNiMgO-Rh exhibited slight decay in the CO2 conversion from 77.6 % to 70.5%, the CH4 conversion decreased from 72.3% to 64.2%. …”
    Get full text
    Get full text
    Get full text
    article
  12. 12

    Sputtered manganese oxide thin film on carbon nanotubes sheet as a flexible and binder-free electrode for supercapacitors by Dawoud H.D.

    Published 2019
    “…CNTs/MnO2 all-solid symmetric supercapacitor using PVA/H3PO4 gel electrolyte exhibited an initial specific capacitance 80F/g and decreased by 25% after 3000 cycles.…”
    Get full text
    Get full text
  13. 13

    Quality improvement can decrease blood delivery turnaround time: Evidence from a single tertiary-care academic medical center by Hammad Y.A.

    Published 2018
    “…The transport time significantly decreased from an initial majority of > 15 mins duration, to a majority of < 15 mins transport time after the second audit; there was a 50% improvement in 30 mins response time; and the percentage of requests processed in < 10 mins were significantly higher after the second audit. …”
    Get full text
  14. 14

    Nutritional quality and health risk of pepper fruit as affected by magnesium fertilization. by Lu, Ming

    Published 2020
    “…As a result, Mg fertilization decreased the comprehensive nutrition level of pepper by 16.6%. …”
    Get full text
    Get full text
  15. 15
  16. 16

    Fabrication of fouling resistant Ti3C2Tx (MXene)/cellulose acetate nanocomposite membrane for forward osmosis application by Alfahel, Radwan

    Published 2020
    “…It was found that the cross-linked cellulose acetate membrane with 8 wt% MXene (CCAM-8%) showed higher resistance to fouling when compared with commercial thin-film composite (TFC) FO membrane, the water flux of CCAM-8% decreased by only 10.7% using TSE as FS compared to DW, where the water flux of the TFC commercial membrane decreased by 32.2% when using TSE as FS compared to DW.…”
    Get full text
    Get full text
  17. 17

    Investigation of the temperature-relatedwear performance of hard nanostructured coatings deposited on a s600 high speed steel by Santecchia E.

    Published 2019
    “…When it comes to machining and cutting tools, thin hard coatings are crucial for decreasing the coefficient of friction (COF) and for protecting tools against oxidation. …”
    Get full text
    Get full text
  18. 18

    Control of the antagonistic effects of heat-assisted chlorine oxidative degradation on pressure retarded osmosis thin film composite membrane surface by Ralph Rolly, Gonzales

    Published 2021
    “…During pressure retarded osmosis (PRO) operation, thin film composite (TFC) membranes are continuously exposed to chemicals present in the stream that can deteriorate the membrane's selective layer with exposure time. …”
    Get full text
    Get full text
    Get full text
  19. 19
  20. 20