-
1
Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating
Published 2015“…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
Get full text
-
2
Biocorrosion behavior of biodegradable nanocomposite fibers coated layer-by-layer on AM50 magnesium implant
Published 2016“…The corrosion performance of coated and uncoated coupon samples was investigated by means of electrochemical measurements. The results showed that the AJS 3D membrane fiber layers, particularly the hybrid membrane layers containing a small amount of nHA (3wt.%), induce a higher biocorrosion resistance and effectively decrease the initial degradation rate compared with the neat AM50 coupon samples. …”
Get full text
Get full text
-
3
The mitochondrial-related effect of the 905 nm photobiomodulation therapy on 50B11 sensory neurons
Published 2023“…In this study, a possible molecular mechanism of the 905 nm PBMT (0.25 W/cm2; 3, 6, 12, and 18 J/cm2, 5 Hz) analgesic effect was tested on 50B11 cells, by investigating its impact on mitochondria. …”
Get full text
Get full text
Get full text
-
4
The spectral and morphological studies of the conductive polyaniline thin film derivatives by the in situ copolymerization
Published 2017“…Thin film of copolymers of poly(aniline-co-2-iodoaniline) are obtained by in situ copolymerization of aniline and 2-iodoaniline as the startup monomers by chemical oxidation upon varying the molar feed to ratio of monomers to procure the different compositions. …”
Get full text
Get full text
-
5
High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling
Published 2014“…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
Get full text
Get full text
-
6
Binding energy, structural, and dielectric properties of thin film of poly(aniline-co-m-fluoroaniline)
Published 2018“…The permittivity of copolymer PA-co-m-FA50 has a higher value than polyaniline in the high-frequency regime and decreases with the increase of frequency. …”
Get full text
Get full text
-
7
-
8
-
9
Quality improvement can decrease blood delivery turnaround time: Evidence from a single tertiary-care academic medical center
Published 2018“…The transport time significantly decreased from an initial majority of > 15 mins duration, to a majority of < 15 mins transport time after the second audit; there was a 50% improvement in 30 mins response time; and the percentage of requests processed in < 10 mins were significantly higher after the second audit. …”
Get full text
-
10
-
11
-
12
Fabrication of fouling resistant Ti3C2Tx (MXene)/cellulose acetate nanocomposite membrane for forward osmosis application
Published 2020“…It was found that the cross-linked cellulose acetate membrane with 8 wt% MXene (CCAM-8%) showed higher resistance to fouling when compared with commercial thin-film composite (TFC) FO membrane, the water flux of CCAM-8% decreased by only 10.7% using TSE as FS compared to DW, where the water flux of the TFC commercial membrane decreased by 32.2% when using TSE as FS compared to DW.…”
Get full text
Get full text
-
13
Investigation of the temperature-relatedwear performance of hard nanostructured coatings deposited on a s600 high speed steel
Published 2019“…When it comes to machining and cutting tools, thin hard coatings are crucial for decreasing the coefficient of friction (COF) and for protecting tools against oxidation. …”
Get full text
Get full text
-
14
Control of the antagonistic effects of heat-assisted chlorine oxidative degradation on pressure retarded osmosis thin film composite membrane surface
Published 2021“…During pressure retarded osmosis (PRO) operation, thin film composite (TFC) membranes are continuously exposed to chemicals present in the stream that can deteriorate the membrane's selective layer with exposure time. …”
Get full text
Get full text
Get full text
-
15
-
16
Electrical characteristics and density of states of thin-film transistors based on sol-gel derived ZnO channel layers with different annealing temperatures
Published 2018“…We report on the fabrication and electrical characterization of bottom gate thin-film transistors (TFTs) based on a sol-gel derived ZnO channel layer. …”
Get full text
Get full text
-
17
-
18
-
19
In vitro effects of photobiomodulation therapy on 50B11 sensory neurons: evaluation of cell metabolism, oxidative stress, mitochondrial membrane potential (MMP), and capsaicin-indu...
Published 2021“…Calcium peak stimulated by capsaicin, the ligand of TRPV1 channel, was decreased in neurons pre-irradiated with the combination of the two wavelengths. …”
Get full text
Get full text
-
20
Experimental analysis of additively manufactured thin-walled heat-treated circular tubes with slits using AlSi10Mg alloy by quasi-static axial crushing test
Published 2019“…In this study, additively manufactured aluminum thin-walled tubes with different slit dimensions are proposed to improve energy absorption efficiency. …”
Get full text
Get full text
