Showing 581 - 600 results of 863 for search '(( 50 ((mean decrease) OR (a decrease)) ) OR ((( a system decrease ) OR ( 9 11 decrease ))))*', query time: 0.17s Refine Results
  1. 581
  2. 582

    An experimental study on achieving even-frosting for an air source heat pump using a novel dual-fan outdoor coil by Bai, Xiaoxia

    Published 2022
    “…The experimental results demonstrated that when using the novel dual-fan outdoor coil in Cases 3, 4 and 7, the heating/frosting duration was lengthened by 23.6%, 34.5% and 46.4%, and the averaged output heating capacity () was increased by 5.5%, 9.5% and 9.6 %, and averaged COP () by 6.7%, 10.5% and 11.1% respectively, and the defrosting frequency was decreased by 33.3% in Case 7,when compared to using the traditional single-fan outdoor coil. …”
    Get full text
    Get full text
  3. 583

    Mechanical and physical behavior of newly developed functionally graded materials and composites of stainless steel 316L with calcium silicate and hydroxyapatite by Ataollahi Oshkour, Azim

    Published 2015
    “…It has been found that the FGMs emerged a better compressive mechanical properties compared to both the composite systems. …”
    Get full text
    Get full text
  4. 584
  5. 585
  6. 586
  7. 587

    Effect of coronavirus-19 restrictions in male handball players: Physical activity, sedentary behavior, and satisfaction with life by Hermassi, Souhail

    Published 2021
    “…Sitting time increased from 2.5 to 4.9 h∙weekday−1 (ηp2 = 0.80) and walking time decreased from 66.8 to 33.5 min∙day−1 (ηp2 = 0.83). …”
    Get full text
    Get full text
  8. 588

    Novel fluorinated surfactants for enhanced oil recovery in carbonate reservoirs by Al-Amodi, Adel O.

    Published 2016
    “…A decrease in oil/water interfacial tension (IFT) of almost one order of magnitude was observed when adding surfactant‐A. …”
    Get full text
    Get full text
  9. 589

    Evaluation of different personalized ventilation air terminal devices: Inhalation vs. clothing-mediated exposures by Al Assaad, Douaa

    Published 2021
    “…Human exposure to particles indoors occurs through direct inhalation or indirectly through deposition on clothes that release them in other spaces. Ventilation systems are installed to decrease direct exposure but little is known about their effect on clothing-mediated exposures. …”
    Get full text
    Get full text
  10. 590

    Mixed siliciclastic-carbonate-evaporite sedimentation in an arid eolian landscape: The Khor Al Adaid tide-dominated coastal embayment, Qatar by John M., Rivers

    Published 2020
    “…The Khor Al Adaid embayment of southern Qatar represents a unique shallow-water mixed siliciclastic‑carbonate coastal depositional system that developed in a hyper-arid climatic setting over the past 6000 years. …”
    Get full text
    Get full text
    Get full text
  11. 591

    Mixed siliciclastic-carbonate-evaporite sedimentation in an arid eolian landscape: The Khor Al Adaid tide-dominated coastal embayment, Qatar by John M., Rivers

    Published 2020
    “…The Khor Al Adaid embayment of southern Qatar represents a unique shallow-water mixed siliciclastic‑carbonate coastal depositional system that developed in a hyper-arid climatic setting over the past 6000 years. …”
    Get full text
    Get full text
    Get full text
    article
  12. 592
  13. 593

    Fluctuations in cardiac stroke volume during rowing by Sejersen, Casper

    Published 2021
    “…Thus, SV decreased by 27 ± 10% (31 ± 11 mL) at the beginning of the stroke and increased by 25 ± 9% (28 ± 10 mL) in the recovery (P =.013), while breathing was entrained with one breath during the drive of the stroke and one prior to the next stroke. …”
    Get full text
    Get full text
    Get full text
  14. 594

    Driver Drowsiness Detection Study using Heart Rate Variability analysis in Virtual Reality Environment by Chowdhury, Muhammad E.H.

    Published 2018
    “…Electrocardiogram (ECG) system was used with three Ag/AgCl electrodes attached to a participant's chest. …”
    Get full text
    Get full text
  15. 595

    Effects of current generation and electrolyte pH on reverse salt flux across thin film composite membrane in osmotic microbial fuel cells by Qin, Mohan

    Published 2016
    “…The OsMFC exhibited 45.9 ± 28.4% lower RSF at the catholyte pH of 3 than that at pH 11 when 40 Ω external resistance was connected. …”
    Get full text
    Get full text
    Get full text
  16. 596

    Energy conversion of heat from abandoned oil wells to mechanical refrigeration - Transient analysis and optimization by Al-Khawaja, Mohammed

    Published 2012
    “…This study investigates the potential of using the geothermal energy from abandoned oils in a novel three-loop system; geothermal, power and cooling loops to produce cooling effect. …”
    Get full text
    Get full text
  17. 597

    Mechanical properties and surface characteristics of an AA6060 alloy strained in tension at cryogenic and room temperature by Xu, Zebing

    Published 2015
    “…When the temperature decreases, the yield strength, the ultimate tensile strength and ductility to fracture are drastically increased from 217.2 MPa, 252.4 MPa, 14.5% to 251.6 MPa, 335.9 Mpa, 21.5% respectively, and the average diameter of dimples decreases from ~8 µm to ~3 µm. …”
    Get full text
    Get full text
  18. 598

    Contrasting cardiovascular mortality trends in Eastern Mediterranean populations: Contributions from risk factor changes and treatments by Critchley, Julia

    Published 2016
    “…Results Risk factor trends: Smoking prevalence was high in men, persisting in Syria but decreasing in Tunisia, oPt and Turkey. BMI rose by 1-2 kg/m2 and diabetes prevalence increased by 40%-50%. …”
    Get full text
    Get full text
  19. 599

    An enhanced performance IPT based battery charger for electric vehicles application by Abdelhamid, E.

    Published 2014
    “…IPT system has proved its capability to be a safe, convenient, and efficient electric vehicle battery charger through its features, such as operating in a harsh environment, high efficiency at reasonable power levels, and decreasing equipment maintenance through operating without any mechanical contacts. …”
    Get full text
    Get full text
  20. 600