Search alternatives:
_ decrease » _ decreased (Expand Search), _ decreases (Expand Search), _ decreasing (Expand Search)
0 decrease » _ decreased (Expand Search), _ decreases (Expand Search)
a point » _ point (Expand Search)
0 0 » 0 30 (Expand Search)
_ decrease » _ decreased (Expand Search), _ decreases (Expand Search), _ decreasing (Expand Search)
0 decrease » _ decreased (Expand Search), _ decreases (Expand Search)
a point » _ point (Expand Search)
0 0 » 0 30 (Expand Search)
-
1
Ferroelectric Properties and Electrocaloric Effect in Dy2O3 Substitution on Lead-Free (Na0.5 Bi0.5)0.94 Ba0.06TiO3 Ceramic
Published 2023“…Higher stability of the ferroelectric (FE) phase was obtained at room temperature for the compositions y = 0.01, 0.02 and 0.05, with optimum values for y = 0.02 as remanent polarization Pr = 32µC/cm2, as well as piezoelectric coefficients d33 = 137 pC/N, kp = 0.27 and kt = 0.16, whereas a higher content of Dy (y = 0.08) induced a remarkable decrease of the ferroelectric and piezoelectric properties. …”
Get full text
-
2
-
3
Structural and magnetic properties of Ni1-xZnxFe 2O4 (x=0, 0.5 and 1) nanopowders prepared by sol-gel method
Published 2013“…The highest coercivity of 50 and 40 Oe, were obtained for NiFe2O 4 and Ni0.5Zn0.5Fe2O4 samples with the grain size of 35 and 29 nm, respectively. …”
Get full text
Get full text
-
4
-
5
-
6
Effect of plastic deformation on Corrosion of cadmium in 0.1 m sodium Sulphate solution
Published 1993“…The results obtained indicate that the cathodic corrosion rate decreases with deformation up to 30-60% RH, depending on the surface finish. …”
Get full text
-
7
Inhibitory effect of sodium nitrite on corrosion of lead in 0.1 M sodium hydroxide solution
Published 1988“…The effect of NaNO2 as an inhibitor for corrosion of lead in 0.1 M NaOH solution has been investigated at different temperatures using the Tafel plot technique. …”
Get full text
-
8
Effect of octylphenol polyethylene oxide on the corrosion inhibition of steel in 0.5 M H2SO4
Published 2004“…A non-ionic surfactant, octylphenol polyethylene oxide (OPPEO), was evaluated as an inhibitor for corrosion of low-carbon steel in 0.5M H 2SO4. Potentiodynamic and potentiostatic methods and scanning electron microscopy were used to study the inhibition effectiveness of the surfactant. …”
Get full text
Get full text
-
9
Pulpal blood flow changes and pain scores related to using superelastic 0.018-inch nickel titanium as the first orthodontic alignment archwire: A prospective clinical trial
Published 2021“…The archwire size group was randomly allocated with a 1:1 allocation ratio. A Laser Doppler Flowmeter was used to measure PBF at different time intervals (T0-T5). …”
Get full text
Get full text
Get full text
-
10
Theoretical and experimental insights into the C-steel aqueous corrosion inhibition at elevated temperatures in 1.0M HCl via multi-carbonyl Gemini cationic surfactants
Published 2023“…The Tafel polarization revealed that at 0.1mM of LAPG and MAPG, the corrosion current density (i corr) of CS was reduced to the lowest extent (75.56 and 53.82μAcm-2) compared to 529.3μAcm-2 in the absence of the inhibitors. …”
Get full text
Get full text
Get full text
-
11
Opportunities, challenges and trade-offs with decreasing avoidable food waste in the UK
Published 2021“…Stakeholder interrelations, regulatory and socio-economic aspects are discussed in relation to their influence on decreasing avoidable food waste. The main output from this work is a diagrammatic depiction of where challenges and trade-offs occur along the food supply chain, and how policy and socio-economic reforms are needed to maximise avoidable food waste prevention, and the surplus avoidable food redistribution in the food supply chain for social benefit.…”
Get full text
Get full text
Get full text
-
12
Turning point in COVID-19 severity and fatality during the pandemic: a national cohort study in Qatar
Published 2023“…In the post-first omicron phase, incidence rate of fatal COVID-19 decreased by 90.0% compared with earlier stages. Both severity and fatality exhibited an exponential increase with age and a linear increase with the number of coexisting conditions. …”
Get full text
Get full text
-
13
A new family of boost active neutral point clamped inverter topology with reduced switch count
Published 2021“…A new family of inverter topology for active neutral point clamped (ANPC) is proposed. …”
Get full text
Get full text
-
14
Impact of magnetic dipole on a thermally stratified ferrofluid past a stretchable surface
Published 2019“…This article focuses on the characteristics of a magnetic dipole in a viscous ferrofluid induced by linear stretched surface. …”
Get full text
Get full text
-
15
-
16
Biocorrosion behavior of biodegradable nanocomposite fibers coated layer-by-layer on AM50 magnesium implant
Published 2016“…The results showed that the AJS 3D membrane fiber layers, particularly the hybrid membrane layers containing a small amount of nHA (3wt.%), induce a higher biocorrosion resistance and effectively decrease the initial degradation rate compared with the neat AM50 coupon samples. …”
Get full text
Get full text
-
17
The mitochondrial-related effect of the 905 nm photobiomodulation therapy on 50B11 sensory neurons
Published 2023“…In this study, a possible molecular mechanism of the 905 nm PBMT (0.25 W/cm2; 3, 6, 12, and 18 J/cm2, 5 Hz) analgesic effect was tested on 50B11 cells, by investigating its impact on mitochondria. …”
Get full text
Get full text
Get full text
-
18
-
19
Understanding the False Positive of Modified Martensitic Steels in Sweet & Sour Service Conditions Using a Point Defect Model Perspective
Published 2023“…These results indicate a critical point in temperature in the tests with only CO2, where resistance to pitting susceptibility is maximized due to a decrease in the cation vacancy diffusivity.…”
Get full text
-
20
A robust experimental-based artificial neural network approach for photovoltaic maximum power point identification considering electrical, thermal and meteorological impact
Published 2020“…Nonetheless, the consideration of irradiance, electrical, thermal, and weather parameters (scenario IV) yielded higher identification accuracy. The results showed a decrease in the MSE of Vmp by 74.3% (from 1.6 V to 0.411 V), and in the MSE of Imp by 95% (from 4.4e−6 A to 2.16e−7 A), respectively. …”
Get full text
Get full text
Get full text