Investigation of the rheological properties of nanosilica-reinforced polyacrylamide/polyethyleneimine gels for wellbore strengthening at high reservoir temperatures by Shamlooh M.

“…The strongest gel was formed with the addition of 2 wt % of 50 nm silica to the polymer base solution which enhanced the gel strength by more than 300%. …”
Get full text
Get full text

Microstructure, wear and corrosion characteristics of Cu matrix reinforced SiC–graphite hybrid composites by Jamwal A.

“…Copper matrix composites with SiC-graphite reinforcement (0, 2.5,5, 7.5 and 10 wt.%) were prepared by stir casting process. …”
Get full text
Get full text

Effects of Combined Calcium Hypochlorite and Chlorine Dioxide on Drinking Water Quality in Qatar and Disinfection by Products Formation by Mohamed, Elsamoul H.

Get full text
Get full text

Influence of nitrogen doping on the electrocatalytic activity of Ni-incorporated carbon nanofibers toward urea oxidation by Barakat, Nasser A.M.

“…However, the electrochemical measurements indicated that the content of the urea in the initial electrospun solution should be optimized as the results showed that the best nickel surface activation as well as the maximum observed current density can be achieved when the urea content is kept at 5 wt%. Typically, the observed current densities using 1.0 M urea (in 1 M KOH) were 3.15, 29.7, 13.75, 47.55, 14.13 and 9.85 mA/cm2 for the nanofibers obtained from electrospun solutions having 0, 1, 2, 5, 7 and 9 wt% urea, respectively. …”
Get full text
Get full text

Synthesis of High-Antifouling and Antibacterial Ultrafiltration Membranes Incorporating Low Concentrations of Graphene Oxide by Alkhouzaam, Abedalkader Ibraheem

“…The pure water permeability (PWP) decreased with loadings of GO from 181.7 L.m-2.h-1.bar-1 of pure PSF to 181.1 and 167.4 L.m-2.h-1.bar-1 with 0.02 and 0.1 wt.% GO respectively. …”
Get full text
Get full text

Isothermal crystallization kinetics and morphology of double crystalline PCL/PBS blends mixed with a polycarbonate/MWCNTs masterbatch by Gumede T.P.

“…For the nanocomposites, there was a decrease in Tc values. This was attributed to a competition between two effects: (1) The partial miscibility of the PC-rich and the PCL-rich and PBS-rich phases, and (2) the nucleation effect of the MWCNTs. …”
Get full text
Get full text

Deoxygenation of pyrolysis vapour derived from durian shell using catalysts prepared from industrial wastes rich in Ca, Fe, Si and Al by Tan, Y.L.

“…With same silica-to-alumina ratio, catalyst prepared from oil palm ash (AS-OPA) with lower Fe and Ca contents gave higher liquid yield (8.32 wt%) with alcohols (28.90%), hydrocarbons (46.00%), and nitrogen-containing compounds (21.46%) while catalyst prepared from electric arc furnace slag (AS-EAF) with higher Fe and Ca contents produced lower liquid yield (50.21 wt%) with high amount of esters (25.80%) and hydrocarbons (72.82%). …”
Get full text
Get full text

A lipidomic screen of hyperglycemia-treated HRECs links 12/15-Lipoxygenase to microvascular dysfunction during diabetic retinopathy via NADPH oxidase by Ibrahim, Ahmed S.

“…Fluorescein angiography and retinal albumin leakage showed a significant decrease in retinal hyperpermeability in streptozotocin-induced diabetic mice lacking 12/15-LOX compared with diabetic WT mice. …”
Get full text
Get full text

Optimization of performance and emission characteristics of CI engine fueled with Jatropha biodiesel produced using a heterogeneous catalyst (CaO) by Singh, A.

“…RSM model was evaluated and found to be adequate as the regression coefficient R2, Adj. R2 and Pred. R2 were found to be satisfactory. …”
Get full text
Get full text

Propagation rate coefficient for sulfobetaine monomers by PLP-SEC by Lacík, Igor

“…The kp values are determined in aqueous solutions for monomer concentrations between 5 and 50 wt % and temperatures between 15 and 80 °C. The propagation rate for SBE is by about a factor of two higher than that for SBAm. …”
Get full text
Get full text

Date palm wood flour/glass fibre reinforced hybrid composites of recycled polypropylene: Mechanical and thermal properties by AlMaadeed, Mariam A.

“…Addition of as little 5wt% glass fibre to wood flour reinforced RPP increases the tensile strength by about 18% relative to the wood flour reinforcement alone. …”
Get full text
Get full text
Get full text

Effect Of The Apical Ectodermal Ridge On Mitotic Index In Hind Limb Bud Mesenchyme In Bufo Regularis by Abdel Karim, Ahmed E.

“…The operated bud (80% of cases) showed a decrease in its volume and there was no significant difference in mesenchyme MI. …”
Get full text

Excess pCO2 and carbonate system geochemistry in surface seawater of the exclusive economic zone of Qatar (Arabian Gulf) by Connor, Izumi

“…The slope suggests that removal of C as CaCO3, organic matter (CH2O) or gas exchange (FCO2) is occurring with a ratio of ΔCaCO3/(ΔCH2O or FCO2) = 1:2.86. The tracer Alk*, defined as the deviation of potential alkalinity (AP) (where AP = TA + 1.26 [NO3]) from conservative potential alkalinity ((ApC), (ApC = S Ap′S′ where A'P and S′ are mean values for the whole surface ocean) has values primarily determined by CaCO3 precipitation and dissolution. …”
Get full text
Get full text
Get full text

Excess pCO2 and carbonate system geochemistry in surface seawater of the exclusive economic zone of Qatar (Arabian Gulf) by Connor, Izumi

“…The slope suggests that removal of C as CaCO3, organic matter (CH2O) or gas exchange (FCO2) is occurring with a ratio of ΔCaCO3/(ΔCH2O or FCO2) = 1:2.86. The tracer Alk*, defined as the deviation of potential alkalinity (AP) (where AP = TA + 1.26 [NO3]) from conservative potential alkalinity ((ApC), (ApC = S Ap′S′ where A'P and S′ are mean values for the whole surface ocean) has values primarily determined by CaCO3 precipitation and dissolution. …”
Get full text
Get full text
Get full text

Artificial weathering and accelerated heat aging studies on low-density polyethylene (Ldpe) produced via autoclave and tubular process technologies by Luyt, A. S.

“…Oligomeric or high molecular weight hindered amine light stabilizer (HALS), and two UV absorbers of benzophenone or hydroxyphenyl-triazine types were equally introduced to both the LDPE grades at a total content of 0.2 wt%. …”
Get full text
Get full text

The cost associated with the development of the antimicrobial stewardship program in the adult general medicine setting in Qatar by Abushanab, Dina

Get full text
Get full text

Uncovering the Epigenetic Contribution of Protein Arginine Methyltransferase 5 (PRMT5) during Zebrafish Cardiomyogenesis by Zakaria, Zain Zaki

“…This was accompanied by a moderate decrease in blood flow (20%), significantly higher decrease in general cardiac output (65%), and reduction in red blood cells count (50%). …”
Get full text

Phase change materials based on high-density polyethylene filled with microencapsulated paraffin wax by Krupa, Igor

“…A modified in situ polymerization microencapsulation procedure for the preparation of microcapsules with paraffin wax cores (43 wt.%) and melamine–formaldehyde resin shells having a uniform size distribution and a spherical shape with average diameters of approximately 15 μm was developed. …”
Get full text
Get full text

Effects of superelastic nano-NiTi additions on electroless Ni –P coating properties under bending by MacLean M.

Get full text
Get full text

Improved flexible, controlled dielectric constant material from recycled LDPE polymer composites by Noorunnisa Khanam, P.

“…In this study, recycled low density polyethylene (RLDPE) is developed with the addition of aluminum oxide (Al2O3) to have new polymer composites. The following wt% were used of the filler (1, 4 and 6 wt%). …”
Get full text
Get full text
Get full text