Comprehensive thermoeconomic, exergoeconomic, and optimization analyses of direct oxy-combustion supercritical CO2 intercooled and reheated cycles under design and off-design condi... by Al-Ammari, Wahib A.

“…At off-design conditions with a power demand (PD) of 40% of the design load (50 MW), the thermal efficiency is decreased by 21.82% in DRC, 17.71% in ICC, 22.46% in PIC, and 13.60% in RHC. …”
Get full text
Get full text
Get full text

Enhancing the Remediation Capacity of Mercury Ions from Fluorescent Lamp Using Roasted Date Pits and Its Modified Forms by Al-Ghouti, Mohammad A.

Get full text
Get full text

Inhibition of Aluminium Corrosion in Hydrochloric Acid by Fouda, A. S. [عبد العزيز السيد فوده]

Get full text

The effect of gossypol, gossypolone and apogossypol on the lipids of male rat Serum and seminal fluid by El sharaky, A. S. [احمد صبحي الشراكي]

Get full text

ELECTRODE SUSPENSION FOR AQUEOUS SODIUM FLOW BATTERY by MESLAM, MENTALLAH MOHAMED HASSANIN MOHAMED HASSANIN

“…At 1.5 wt% KB, the anolytes could tolerate high load (25 wt%) of NTO without severe rise in the rigidity and conductivity under static and flow modes. …”
Get full text

Thermally conductive polyethylene/expanded graphite composites as heat transfer surface: Mechanical, thermo-physical and surface behavior by Sobolčiak, Patrik

“…This enhanced surface wettability was retained over a long time with only a 9% and 18% decrease in RF and corona plasma-treated samples' surface energy after two months. …”
Get full text
Get full text

Study of performance, combustion, and emissions parameters of DI-diesel engine fueled with algae biodiesel/diesel/n-pentane blends by Elkelawy, Medhat

“…Through performance tests, it was found that 15 ml of n-pentane per liter was the best addition as it caused an increase in the brake thermal efficiency of 7.1% and a decrease in brake specific fuel consumption of 6.4% compared to the elegant B50. …”
Get full text
Get full text

Mechanical Performance and Thermo-Physical Properties of Cement Mortar Incorporating Hybrid Slags by Baawain, Mahad

“…Ferrochrome (FeCr) slag aggregate was used as a replacement for sand at the ratios of 25, 50, 75 and 100 wt. %. …”
Get full text
Get full text

Enhanced quality factor of polyvinyl formal (PVF) based nanocomposites filled with zinc oxide and carbon black nanoparticles for wireless sensing applications by Mohanapriya, M.K.

“…The incorporation of ZnO at 10% decreases Q-factor to 36.1. Incorporation of CBNP at 5% and ZnO at 5% further reduces the Q-factor to 13.7. …”
Get full text
Get full text

Biodegradable polysaccharide grafted polyacrylamide inhibitor for corrosion in CO2- saturated saline solution by Jalab, Rem

“…Lastly, potentiostatic testing of steel with AGGPAM at an applied potential of 50 mV illustrated surface protection and decreased current over a prolonged time. …”
Get full text
Get full text

Antibacterial Properties of Polysulfone Membranes Blended with Arabic Gum. by Sabri, Souhir

Get full text
Get full text

Tailoring electrocatalytic properties of Pt nanoparticles grown on Ti3C2Tx MXene surface by Filip, Jaroslav

“…Composites containing 14 wt% Pt showed HER with an onset potential of −75.9 mV and a current density of −10 mA cm−2 achieved at −226 mV. …”
Get full text
Get full text
Get full text

PERFORMANCE OPTIMIZATION OF PROPANE PRE-COOLED MIXED REFRIGERANT (C3MR) PROCESS FOR NATURAL GAS LIQUEFACTION by SHADY, ROBA TAWFIK SAAD MOHAMED

Get full text

Conversion of Organic Municipal Wastes into Biochars and their Effect on Fertility Parameters of Normal and Sabkha Soils of Qatar by Ahmedna, Mohamed

“…To each pot, sufficient amount of 0.25-mm sieved biochar was mixed with soil to yield carbon to soil ratios of 0, 1, and 2% (wt/wt). Box-Behnken experimental design was used instead of the full factorial to decrease the number of treatments to a manageable level (126 treatments) with three replications at the center. …”
Get full text
Get full text

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study by Hamza A.

“…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …”
Get full text
Get full text
Get full text

Synthesizing New Anodes From Qatalum's 1st Cut Spl by Hani Holozadah, Abdullah

“…This might result in extending the life time of the carbon anodes and decrease the number of carbon dioxide kilograms that are released per a ton of produced Al metal. …”
Get full text
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

Microstructure, wear and corrosion characteristics of Cu matrix reinforced SiC–graphite hybrid composites by Jamwal A.

“…Copper matrix composites with SiC-graphite reinforcement (0, 2.5,5, 7.5 and 10 wt.%) were prepared by stir casting process. …”
Get full text
Get full text

Effect of gamma irradiation on the microstructure and morphology of polyethylene oxide and polyvinyl alcohol blends by Al-Maadeed, M.

“…Thin films of a blend of 90, 75, 50 (wt/wt%) percentage of polyethylene oxide and polyvinyl alcohol were synthesized and irradiated with 5, 25, 50, 100 and 200 kGy. …”
Get full text
Get full text

Contrasting effects of necrotrophic and biotrophic plant pathogens on the aphid Aphis fabae by Al-Naemi, F.

“…However, sequential plant infection (pathogens applied 5 days apart) led to a 70% decrease in fecundity and 50% reduction in intrinsic rate of increase. …”
Get full text
Get full text