Investigation of the Effect of Imatinib and Hydroxyurea Combination Therapy on Hematological Parameters and Gene Expression in Chronic Myeloid Leukemia (CML) Patients by Al-Amleh, Esraa K.

“…Platelet counts, on the other hand, dramatically decreased in both IM and (HU + IM). (4) Conclusion: Because the studied genes (BCL2, PP2A, CIP2A, and WT1) are participating in cell proliferation and death, the findings show that the examined genes are significant to understand the efficacy of various therapies. …”
Get full text
Get full text

Investigating the effect of polymer-modified graphene oxide coating on RO membrane fouling by Ashfaq, Mohammad Y.

“…The membrane surface characterization showed a decrease in membrane surface roughness from 74.7 nm to 69.0 nm and an increase in membrane hydrophilicity as the contact angle decreased from 41.7 ± 4.50 to 22.0 ± 1.10. …”
Get full text
Get full text

Experimental investigation on the compressibility of Al/Al2O3 nanocomposites by Wagih, Ahmed

“…With up to 12 wt.% of Al2O3, microhardness increases from 62 to 150 HV due to the decrease of the crystallite size. …”
Get full text
Get full text

Comparison of performance and health indicators between perimenopausal and postmenopausal obese women: the effect of high-intensity interval training (HIIT). by Jabbour, Georges

“…Anthropometric parameters, mechanical efficiency (ME in %), lipid oxidation (LO in %), and low and high spectral frequencies (LF[ms2] and HF[ms2]) were computed pre- and postintervention. …”
Get full text
Get full text

ELECTRODE SUSPENSION FOR AQUEOUS SODIUM FLOW BATTERY by MESLAM, MENTALLAH MOHAMED HASSANIN MOHAMED HASSANIN

“…At 1.5 wt% KB, the anolytes could tolerate high load (25 wt%) of NTO without severe rise in the rigidity and conductivity under static and flow modes. …”
Get full text

Thermal characterization of phase change materials based on linear low-density polyethylene, paraffin wax and expanded graphite by Sobolciak, Patrik

“…A similar decrease in sensible heat with increased loading of EG was observed for PCMs containing 50 wt.% of EG. …”
Get full text
Get full text

Impact of aluminium acetate particles size on the gelation kinetics of polyacrylamide-based gels: Rheological and molecular simulation study by Hamza A.

“…The addition of bentonite at low crosslinker concentrations (0.5–1 wt.%) did not decrease the gel strength of 7 wt.% PAM/1 wt.% AlAc significantly. …”
Get full text
Get full text
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…The compressive strength of composite sample containing 2.0 wt. % ZrO2 and graphite was found to be 674.57 MPa which was around 1.25% higher than the composite sample containing 0.5 wt. % reinforcements. …”
Get full text
Get full text
Get full text

Improvement of ternary recycled polymer blend reinforced with date palm fibre by Khanam, P. Noorunnisa

“…The date palm fibre reinforced composites (CD00) were prepared by maintaining constant weight% of fibre of 20wt% without any fibre treatment. Maleic anhydride (MA) was used as the compatabilizer (1 and 2wt%) and the effect of compatabilizer on the blend matrix composites was studied. …”
Get full text
Get full text
Get full text

Mechanical Performance and Thermo-Physical Properties of Cement Mortar Incorporating Hybrid Slags by Baawain, Mahad

“…Furthermore, Increasing replacement ratios of FeCr aggregates over 25 wt. % have resulted in noticeable decrease in thermal conductivity and an increase in the permeable voids content of cement mortars. …”
Get full text
Get full text

Production and investigation of flexible nanofibers of sPEEK/PVP loaded with RuO2 nanoparticles by Chamakh, Mariem

“…The samples were synthesized with different concentrations of hydrous ruthenium chloride of 2 wt%, 5 wt%, and 10 wt%, and then annealed at a temperature of 300 �C for 4 h to form the ruthenium oxide nanoparticles. …”
Get full text
Get full text

Thermally conductive polyethylene/expanded graphite composites as heat transfer surface: Mechanical, thermo-physical and surface behavior by Sobolčiak, Patrik

“…Composites of high-density polyethylene (HDPE) and expanded graphite (EG) are prepared for heat exchangers in multi-effect distillation (MED) desalination. At 50 wt.% EG loading, the thermal conductivity of HDPE was increased by 372%. …”
Get full text
Get full text

Microstructure, wear and corrosion characteristics of Cu matrix reinforced SiC–graphite hybrid composites by Jamwal A.

“…Composite containing 5 wt.% reinforcement has shown minimum wear rate and maximum corrosion resistance. …”
Get full text
Get full text

Modification of Pd/CeO2 catalyst by Atomic Layer Deposition of ZrO2 by Onn, Tzia Ming

“…Modification of a 1 wt% Pd/CeO2 catalyst by Atomic Layer Deposition of thin ZrO2 films was studied. …”
Get full text
Get full text

Structural, wear and thermal behaviour of Cu–Al2O3–graphite hybrid metal matrix composites by Mittal, P.

“…Composite containing 2.0 wt% reinforcements showed the maximum resistance to wear. …”
Get full text
Get full text

Changes In Biomass Gain, Protein Content And Hormonal Levels In Wheat Kernels In Response To Soil Drench With Sodium Salicylate by Abo Hamed, S. A.

“…Drenching of soil with sodim salycylate (800,4000 and 8000mg/l) increased grain f. wt. and d. wt. Protein content was increased in grains at days 23 and 60 with 800 mg/1 salicylate. …”
Get full text

Evaluation of the Effect of Moringa peregrina Extract on Learning and Memory: Role of Oxidative Stress by Alzoubi, Karem H.

“…Male Wistar rats were administered via oral gavage three dose levels (50, 100, and 500 mg/kg) of M. peregrina methanolic extract for 2 months. …”
Get full text
Get full text

Date palm wood flour/glass fibre reinforced hybrid composites of recycled polypropylene: Mechanical and thermal properties by AlMaadeed, Mariam A.

“…Addition of as little 5wt% glass fibre to wood flour reinforced RPP increases the tensile strength by about 18% relative to the wood flour reinforcement alone. …”
Get full text
Get full text
Get full text

Influence of nitrogen doping on the electrocatalytic activity of Ni-incorporated carbon nanofibers toward urea oxidation by Barakat, Nasser A.M.

“…However, the electrochemical measurements indicated that the content of the urea in the initial electrospun solution should be optimized as the results showed that the best nickel surface activation as well as the maximum observed current density can be achieved when the urea content is kept at 5 wt%. Typically, the observed current densities using 1.0 M urea (in 1 M KOH) were 3.15, 29.7, 13.75, 47.55, 14.13 and 9.85 mA/cm2 for the nanofibers obtained from electrospun solutions having 0, 1, 2, 5, 7 and 9 wt% urea, respectively. …”
Get full text
Get full text

Experimental and theoretical studies on the mechanical and structural changes imposed by the variation of clay loading on poly(vinyl alcohol)/cloisite 93A nanocomposites by Kabalan L.

“…Young modulus calculated theoretically follows the same experimental trend where an increase of the values has been observed with a clay loading up to 3 wt%, followed by a decrease of the values for higher clay loading. …”
Get full text
Get full text