Search alternatives:
ng decrease » _ decrease (Expand Search)
fe decrease » _ decrease (Expand Search)
al decrease » _ decrease (Expand Search)
e decrease » _ decrease (Expand Search), _ decreased (Expand Search), _ decreases (Expand Search)
50 ng » 10 ng (Expand Search), 50 μg (Expand Search)
_ fe » _ e (Expand Search)
_ al » _ a (Expand Search)
ng decrease » _ decrease (Expand Search)
fe decrease » _ decrease (Expand Search)
al decrease » _ decrease (Expand Search)
e decrease » _ decrease (Expand Search), _ decreased (Expand Search), _ decreases (Expand Search)
50 ng » 10 ng (Expand Search), 50 μg (Expand Search)
_ fe » _ e (Expand Search)
_ al » _ a (Expand Search)
-
1
-
2
Structural evaluation, preliminary in vitro stability and electrochemical behavior of apatite coatings on Ti6Al4V substrates
Published 2016“…Medical-grade alloys, such as Ti-6Al-4V, have been used for fixation of fractured bone and for the total replacement of defective bone. …”
Get full text
Get full text
-
3
A quality of experience-aware association algorithm for 5G heterogeneous networks
Published 2017“…To this end, we consider a 5G Heterogeneous Network (HetNet) deployment where MNOs use a QoE-based charging scheme. …”
Get full text
Get full text
-
4
Deoxygenation of pyrolysis vapour derived from durian shell using catalysts prepared from industrial wastes rich in Ca, Fe, Si and Al
Published 2020“…Catalysts prepared from industrial wastes rich in Fe, Ca, Si, and Al were used in catalytic upgrading of pyrolysis vapour derived from durian shell and their effect on product yield and properties were compared. …”
Get full text
Get full text
-
5
-
6
Structural and magnetic properties of Ni1-xZnxFe 2O4 (x=0, 0.5 and 1) nanopowders prepared by sol-gel method
Published 2013“…A series of nanostructured Ni-Zn ferrites Ni1-xZn xFe2O4 (x=0, 0.5 and 1) with a grain size from 24 to 65 nm have been prepared with a sol-gel method. …”
Get full text
Get full text
-
7
Kinetics and mechanism of H2O2 decomposition by Cu(II)-, Co(II)-, and Fe(III)-Amine complexes on the surface of Silica-Alumina (25% Al2O3)
Published 1994“…The kinetics of the H2O2 decomposition by Cu(II)-, Co(II)-, and Fe(III)-amine complexes supported on the surface of silica-alumina (25% Al2O3) catalyst have been investigated. …”
Get full text
Get full text
-
8
Experimental investigation on the compressibility of Al/Al2O3 nanocomposites
Published 2016“…With up to 12 wt.% of Al2O3, microhardness increases from 62 to 150 HV due to the decrease of the crystallite size. …”
Get full text
Get full text
-
9
Correlating the rheological and magneto-optical properties of cobalt substituted magnetite ferrofluids (CoxFe1?xFe2O4) with theoretical studies
Published 2023“…An environmental friendly method of co-precipitation is applied to generate CoxFe1?xFe2O4 with variable dopant concentration (x = 0-0.8), which is deeply investigated by structural and functional property analyses of the ferrofluids. …”
Get full text
Get full text
-
10
Phase, microstructure and tensile strength of Al–Al2O3–C hybrid metal matrix composites
Published 2020“…Aluminium matrix reinforced with Al2O3–carbon (2.5, 5, 7.5 and 10 wt.%) in equal proportion was prepared by stir casting. …”
Get full text
Get full text
-
11
-
12
-
13
Correlation of structural and mechanical properties for Al-Al2O3-SiC hybrid metal matrix composites
Published 2021“…Al-Al2O3-SiC hybrid composite has been developed through stir casting with addition of ceramics i.e. …”
Get full text
Get full text
-
14
Decreased number of acute appendicitis cases in pediatric population during the COVID-19 pandemic: Any link?
Published 2020“…The reasons behind the decrease in AA frequency during the COVID-19 pandemic remain unclear. …”
Get full text
Get full text
-
15
Structural and mechanical characterization of stir cast Al–Al2O3–TiO2 hybrid metal matrix composites
Published 2020“…Scanning electron microscopy shows that aluminium matrix has uniform distribution of reinforcement particle i.e. aluminium oxide and titanium oxide. Density of composite decreases due to variation of reinforcement and it shows low density after preheating. …”
Get full text
Get full text
-
16
Effect of reinforcement concentration on the properties of hot extruded Al-Al2O3 composites synthesized through microwave sintering process
Published 2017“…Results showed that, as the content of hard ceramic particles increases, it improves overall mechanical properties including microhardness, 0.2% yield strength, ultimate compression/tensile strength, and Young's modulus while the ductility and co-efficient of thermal expansion decreases. XRD patterns and SEM/EDS mapping images show a uniform distribution of Al2O3 particles in the Al matrix. …”
Get full text
Get full text
-
17
Effect of reinforcement concentration on the properties of hot extruded Al-Al2O3 composites synthesized through microwave sintering process
Published 2017“…Results showed that, as the content of hard ceramic particles increases, it improves overall mechanical properties including microhardness, 0.2% yield strength, ultimate compression/tensile strength, and Young's modulus while the ductility and co-efficient of thermal expansion decreases. XRD patterns and SEM/EDS mapping images show a uniform distribution of Al2O3 particles in the Al matrix. …”
Get full text
Get full text
Get full text
-
18
Improved properties of Al-Si3N4 nanocomposites fabricated through a microwave sintering and hot extrusion process
Published 2017“…The thermal expansion coefficient of the Al composite decreased with the progressive addition of hard Si3N4 nanoparticles. …”
Get full text
Get full text
-
19
-
20
Fabrication of zno-fe-mxene based nanocomposites for efficient co2 reduction
Published 2020“…Nyquist plots also illustrated a decrease in the impedance of the ZnO-Fe-MXene layer, indicating fast charge transfer between the Zn and MXene layers. …”
Get full text
Get full text