Showing 1 - 20 results of 384 for search '(( 50 pp decrease ) OR ((((( 1_ fe decrease ) OR ( _ fe decrease ))) OR ( 50 i decrease ))))', query time: 0.22s Refine Results
  1. 1

    Structural and magnetic properties of Ni1-xZnxFe 2O4 (x=0, 0.5 and 1) nanopowders prepared by sol-gel method by Gao P.

    Published 2013
    “…A series of nanostructured Ni-Zn ferrites Ni1-xZn xFe2O4 (x=0, 0.5 and 1) with a grain size from 24 to 65 nm have been prepared with a sol-gel method. …”
    Get full text
    Get full text
  2. 2

    Correlating the rheological and magneto-optical properties of cobalt substituted magnetite ferrofluids (CoxFe1?xFe2O4) with theoretical studies by Babukutty, B.

    Published 2023
    “…Faraday rotation of CoxFe1?xFe2O4 ferrofluids is measured depending on the different concentrations of cobalt in applied magnetic field. …”
    Get full text
    Get full text
  3. 3

    Functionalization of silica-coated magnetic nanoparticles as powerful demulsifier to recover oil from oil-in-water emulsion by Elmobarak W.F.

    Published 2021
    “…The highest %Soil achieved with Fe– Si-1 Fe–Si-2 and Fe–Si-3 was >95%, 95% and 92%, respectively. …”
    Get full text
    Get full text
  4. 4

    Modified zno nanoparticles using iron ions (Fe3+) for photo-catalytic degradation of toxic pollutants under sunlight by Ba-Abbad, Muneer M.

    Published 2019
    “…As the Fe3+ concentration increased from 0.25 to 1.00 wt. %, the crystal size decreased in comparison with the undoped ZnO. …”
    Get full text
  5. 5
  6. 6

    Application of Fe3O4 magnetite nanoparticles grafted in silica (SiO2) for oil recovery from oil in water emulsions by Elmobarak W.F.

    Published 2021
    “…Demulsification process best fits the combined Langmuir-Freundlich (L-F) isotherm with highest adsorption capacity (Qmax) of 186.0 ± 5 mgoil/gMD compared to 86.0 ± 5 mgoil/gMD for Fe3O4, which is 1.1 folds greater than Qmax reported in the literature for other demulsifiers.…”
    Get full text
    Get full text
  7. 7

    Deoxygenation of pyrolysis vapour derived from durian shell using catalysts prepared from industrial wastes rich in Ca, Fe, Si and Al by Tan, Y.L.

    Published 2020
    “…With same silica-to-alumina ratio, catalyst prepared from oil palm ash (AS-OPA) with lower Fe and Ca contents gave higher liquid yield (8.32 wt%) with alcohols (28.90%), hydrocarbons (46.00%), and nitrogen-containing compounds (21.46%) while catalyst prepared from electric arc furnace slag (AS-EAF) with higher Fe and Ca contents produced lower liquid yield (50.21 wt%) with high amount of esters (25.80%) and hydrocarbons (72.82%). …”
    Get full text
    Get full text
  8. 8
  9. 9
  10. 10

    Application of magnetic nanoparticles for the removal of oil from oil-in-water emulsion: Regeneration/reuse of spent particles by Elmobarak W.F.

    Published 2021
    “…The observed %Roil at a pH of 4 and Csur of 0.05 g/L was observed to be > 90 ± 0.1% and decreased by either rising the pH to 7 or increasing the Csur to 0.1 g/L. …”
    Get full text
    Get full text
  11. 11

    Kinetics and mechanism of H2O2 decomposition by Cu(II)-, Co(II)-, and Fe(III)-Amine complexes on the surface of Silica-Alumina (25% Al2O3) by Salem, Mohamed A.

    Published 1994
    “…With ethylenediamine as aligand, the rate has also decreased in the order: Cu(II) > Co(II) > Fe(III). …”
    Get full text
    Get full text
  12. 12

    In vitro effects of photobiomodulation therapy on 50B11 sensory neurons: evaluation of cell metabolism, oxidative stress, mitochondrial membrane potential (MMP), and capsaicin-indu... by Zupin, Luisa

    Published 2021
    “…Calcium peak stimulated by capsaicin, the ligand of TRPV1 channel, was decreased in neurons pre-irradiated with the combination of the two wavelengths. …”
    Get full text
    Get full text
  13. 13
  14. 14

    The mitochondrial-related effect of the 905 nm photobiomodulation therapy on 50B11 sensory neurons by Zupin, Luisa

    Published 2023
    “…PBMT at 18 J diminished the mitochondrial membrane potential, and influenced mitochondrial respiration, decreasing the oxygen consumption rate. Finally, a decrement of extracellular signal-regulated kinase 1/2 phosphorylation was observed with the protocol using 12 J. …”
    Get full text
    Get full text
    Get full text
  15. 15

    Tailoring of the thermal, mechanical and dielectric properties of the polypropylene foams using gamma-irradiation by Mrl�k, Miroslav

    Published 2016
    “…Investigated mechanical properties in case of tensile tests as well as dynamical mechanical analysis proved, that enhanced behaviour was observed only in case of samples with irradiated by low doses, 1 kGy and 5 kGy, respectively, while the higher doses significantly decrease these ones, due to the present scission confirmed by FTIR and other investigations. …”
    Get full text
    Get full text
  16. 16

    Fabrication of zno-fe-mxene based nanocomposites for efficient co2 reduction by Kannan, K.

    Published 2020
    “…Nyquist plots also illustrated a decrease in the impedance of the ZnO-Fe-MXene layer, indicating fast charge transfer between the Zn and MXene layers. …”
    Get full text
    Get full text
  17. 17

    Magneto-Mechanical and Thermal Properties of Nd-Fe-B-Epoxy-Bonded Composite Materials by Grujić, Aleksandar

    Published 2023
    “…The results show that impact toughness decreases, while magnetic properties increase, along with increasing content of Nd-Fe-B. …”
    Get full text
    Get full text
    Get full text
  18. 18

    Adsorption of Congo Red Dye Using Activated Carbon-Fe3O4 Composite by Mahmud, Nafis

    Published 2023
    “…Initial dye concentration also had significant impact on the adsorption process as the adsorption capacity of the AC- Fe3O4 adsorbents decreased with increase in dye concentrations. …”
    Get full text
    Get full text
  19. 19

    Quality improvement can decrease blood delivery turnaround time: Evidence from a single tertiary-care academic medical center by Hammad Y.A.

    Published 2018
    “…The transport time significantly decreased from an initial majority of > 15 mins duration, to a majority of < 15 mins transport time after the second audit; there was a 50% improvement in 30 mins response time; and the percentage of requests processed in < 10 mins were significantly higher after the second audit. …”
    Get full text
  20. 20