Novel fluorinated surfactants for enhanced oil recovery in carbonate reservoirs by Al-Amodi, Adel O.

“…A decrease in oil/water interfacial tension (IFT) of almost one order of magnitude was observed when adding surfactant‐A. …”
Get full text
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

Superior photocatalytic activity of Cu doped NiWO4 for efficient degradation of benzene in air even under visible radiation by Tri N.L.M.

“…This was because Cu effectively acted as novel dopant, which not only affected valence band (VB) top and conduction band (CB) bottom of NiWO4 but also formed a medium energy level between CB and VB of the NiWO4 to decrease its energy band gap and electron-hole recombination rate. …”
Get full text
Get full text

Roadmap toward energy-positive upfront nitrogen removal process in baseload LNG plant by Mkacher, Hajer

“…The results show that UNrem of 87.5% from the NG feed can reduce the total power requirements by 0.24%, increase the production flow rate by 4.4%, and decrease the exergy losses by 0.23% compared with the base case. …”
Get full text
Get full text

Improvement of both lipid and biomass productivities of Qatar Chlorocystis isolate for biodiesel production and food security by Saadaoui, Imen

“…Most previous research evidenced that the increase of the lipid content is accompanied by a decrease of the biomass production, which increases the cost of the downstream processing. …”
Get full text
Get full text

Recycled Polypropylene Fibres for Reinforcing Cement Mortar under Arid Conditions by Bendjillali, Khadra

Get full text
Get full text

Short-term greenhouse emission lowering effect of biochars from solid organic municipal wastes by Rehrah D.

“…A significant decrease in CO2 emission was observed in vials with soil–biochar mixtures, especially for biochars produced at 500 °C compared the corresponding raw materials which exhibited an exponential increase in the CO2 emission. …”
Get full text
Get full text

Trends in prevalence of depression and anxiety symptoms and effects of sociodemographic variables before and after the first wave of COVID-19 in Qatar by Khaled, Salma M.

“…The data for 2020/21 showed a 35.1% and 29.2% decrease in depression and anxiety symptoms scores compared to pre-pandemic years (2017/2018) after adjusting for sociodemographic factors. …”
Get full text
Get full text

Influence of shelf-life duration on mechanical, thermal and shape recovery motion derivatives of shape memory polyurethane by Vasavi, Boggarapu

“…In addition, Differential scanning calorimetry (DSC)exhibited a decrease in glass transition temperature (Tg) from S1 to S10, resulting in a corresponding reduction in the rate of shape restoration. …”
Get full text
Get full text
Get full text

Fecal Carriage and Molecular Characterization of Carbapenemase-Producing Enterobacterales in the Pediatric Population in Qatar by Pérez-López, Andrés

“…Whole-genome sequencing was used to characterize carbapenemase-producing Enterobacterales (CPE) strains recovered from rectal screening swab samples obtained from children at a tertiary-care pediatric hospital in Qatar during a 3-year period. …”
Get full text
Get full text
Get full text

Modeling of dual-metal Schottky contacts based silicon micro and nano wire solar cells by Rabbani, M. Golam

Get full text
Get full text

Electrospun polylactic acid/date palm polyphenol extract nanofibres for tissue engineering applications by Khadija M., Zadeh

“…Increasing the polyphenol concentration caused the tensile strength and Young’s modulus to decrease. The SEM graphs indicated a decrease in fibre diameter with increasing DP content. …”
Get full text
Get full text

Mixed Solid Municipal Waste-Based Biochar for Soil Fertility and Greenhouse Gas Mitigation by Bansode, Rishipal

“…Municipal solid waste management is one of the major challenges facing Qatar with more than 2.5 million tons of municipal solid waste each year, a very high waste generation rate in a country with small land mass. …”
Get full text
Get full text

Undrained interface shear strength of fine-grained soils for near-shore marine pipelines by Eid, Hisham T.

“…The peak and residual interface shear strengths for a variety of normally consolidated soils were measured using a torsional ring shear apparatus modified to suit soil and interface testing under the undrained condition, which is usually prevalent at soil-marine pipeline interfaces. …”
Get full text
Get full text

Novel voltage balancing algorithm for single-phase cascaded multilevel inverter for post-module failure operation in solar photovoltaic applications by Rahman S.

Get full text
Get full text

Structural and electrochemical properties of electrodeposited Ni-P nanocomposite coatings containing mixed ceramic oxide particles by Zadeh, K.M.

Get full text
Get full text

Unlocking the application potential of electrocoagulation process through hybrid processes by Almukdad, Abdulkarim

Get full text
Get full text

An Overview of Solid Waste Management and Plastic Recycling in Qatar by Al-Maaded, M.

“…The analysis showed that Qatar produced around 2,000,000 tons of solid municipal waste annually, corresponding to a daily generation rate per capita of about 2. 5 kg. …”
Get full text
Get full text

Interface modification of compatibilized polyethylene terephthalate/polypropylene blends: Effect of compatibilization on thermomechanical properties and thermal stability by Inuwa, Ibrahim M.

“…PET, PP, and SEBS-g-MAH were melt-blended in a single stLGusing the counter rotating twin screw extruder with compatibilizer concentrations of 0, 5, 10, and 15 phr, respectively. …”
Get full text
Get full text

Changes in Copepod Community Structure in Response to Land-Based Activities along Alexandria Coastline, Mediterranean Sea by El Din, Nehad M. Nour [نهاد مصطفى نور الدين]

“…Industrial discharge exerted the highest impact on the copepod population by decreasing its density to less than 500 ind./m3. Despite the decrease m copepod abundance during high flow of sewage, the impacted area sustained the maximum copepod density low discharge i.e. 11,222 ind.…”
Get full text