Cephalometric measurement points. by Lijuan Liu (136685)

Subjects:

Units of non-point source agricultural pollution. by Cangyu Li (10312677)

“…The main source of TN emissions has shifted from livestock to farmland straw; (2) the total pollutant load exhibited a distinct spatial distribution pattern. Specifically, the southern part of the study area had the highest pollutant loads, followed, respectively, by the eastern, northern, and western parts; (3) the decoupling relationship between ANPSP emissions and agricultural output values showed fluctuating changes, dominated by weak and strong decoupling status, with gradual improvement. (4) Henan Province was divided into three primary non-point source pollution control zones using cluster analysis, namely high, moderate, and low-risk zones. …”

The introduction of mutualisms into assembled communities increases their connectance and complexity while decreasing their richness. by Gui Araujo (22170819)

“…(C) Mutualism also promotes an increase in network connectance when introduced into assembled communities, while stopping mutualistic interactions from entering an assembled system slowly decreases it. (D) As a result, the introduction of mutualistic interactions promotes a growth in complexity in communities where it was once established as low, while stopping the introduction of further mutualistic interactions causes a slight decrease in complexity. …”

Does a correlation exist between delayed vaccination and a decreased vaccine confidence? by Virginia Reverte (9046494)

“…Online questionnaire was sent to their parents, followed by a telephone questionnaire for non-responders. Regarding MMR first dose, a significant association was found between delay and birth order and intellectual/motor delay of children. …”

Intent to decrease use of OTC NSAIDs and NSAID exposure. by Matthew G. Vinson (22593374)

“…<p>(A) Scatter plot of the group effect on intent to decrease use of OTC NSAIDs at pre-intervention and post-intervention. …”

Percent pollution of different agricultural non-point sources pollutants between 2001 and 2023 in Henan Province, China. by Cangyu Li (10312677)

(A) Auxiliary marking points to ensure complete and accurate seating of the prosthesis. by Long Li (6555)

Subjects:

Ignition delay process shot by high-speed camera. by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

Data disclosure (Bai - manuscript). by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

Experimental bench and corresponding facility. by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

Three classic combustion stages of the flame. by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

Flame binarization image processing flow. by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

Experimental condition of fixed oil drop volume. by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

Schematic diagram of experimental injector size. by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

Droplet boiling modes at different temperatures. by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

Risk Classification Diagram of Hot Surface. by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

Physical parameters of engine lubricating oil. by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

Variation of heat flow with wall temperature. by Lei Bai (631944)

“…The main findings of this study are as follows: (1) As the temperature of the hot surface increases, the ignition delay time generally shows a decreasing trend, with 450°C being a critical turning point; (2) There is an overlap between ignition and non-ignition cases within a specific range, forming a possible ignition zone, and the <i>R</i>² values of the fitting equations for the upper and lower boundaries are both above 95%, indicating a good fit. (3) The fractal dimension can effectively quantify the geometric complexity of the flame’s outer contour, thereby characterizing the stability of the flame’s combustion. …”

The resistivity at a depth of 18cm at different time points under unsaturated conditions varies with depth. by Kui Suo (20614613)

Larger example of stimuli with cue relevant for Task 3. by Marcel F. Hinss (14675457)