Showing 1,161 - 1,180 results of 1,801 for search '(( a 10 decrease ) OR ( 5 ((step decrease) OR (((mean decrease) OR (a decrease)))) ))', query time: 0.17s Refine Results
  1. 1161

    Semi-continuous anaerobic digestion of the organic fraction of municipal solid waste: digester performance and microbial population dynamics by Najoua, Mlaik

    Published 2022
    “…Three organic loading rates (OLRs) were tested throughout the anaerobic process (1.36, 2.5 and 3.5 g VS/L.d). The achieved results showed that biogas yield decreased with the increase of OLR. …”
    Get full text
    Get full text
    Get full text
  2. 1162

    Evaluation of the Mechanical Properties of AA 6063 Processed by Severe Plastic Deformation by Jafarlou, Davoud Mashhadi

    Published 2015
    “…HA of AA6063 increased the fatigue and fretting fatigue lives of SPD + HT-processed samples at low cycle by 15.5 and 18.4 pct respectively; however, at high cycle, HA had reverse effects, whereby the fatigue and fretting fatigue lives of SPD + HT-processed samples decreased by 16.7 and 30 pct, respectively.…”
    Get full text
    Get full text
  3. 1163

    Thermodynamic analysis of solar-driven chemical looping steam methane reforming over Cr2O3/Cr redox pair by Bhosale, Rahul

    Published 2019
    “…The total solar energy required to drive the CS process (Q-solar-CS) rises by 1498.8 kW as the CH4/Cr2O3 molar ratio upsurges from 0.5 to 3. In case of the CSH process, when the TL increases from 500 to 1400 K, the Q solar CSH decreases by 54.5 kW and further surge in the TL from 1400 to 2050 K yields into upturn in the Q-solar-CSH by 108.5 kW. …”
    Get full text
    Get full text
  4. 1164
  5. 1165
  6. 1166

    Effect of sintering temperature of NBT–6BT lead-free ceramics on the structural, ferroelectric and piezoelectric properties by Slimani, Ahmed

    Published 2022
    “…The lead-free Na 0.5 Bi 0.5 0.94 Ba 0.06 TiO 3 (NBT-6BT) ceramics was fabricated at various sintering temperatures using a conventional solid-state reaction method. …”
    Get full text
  7. 1167
  8. 1168
  9. 1169
  10. 1170
  11. 1171
  12. 1172

    Investigation Into the Effects of Non-Linear Loading of Domestic Power Network on Home Appliances by Hossain, Ajad

    Published 2016
    “…Supply from a single-phase Inverter with Fundamental frequency (50 Hz) only: Fig. 5. …”
    Get full text
    Get full text
  13. 1173

    Mechanical properties and surface characteristics of an AA6060 alloy strained in tension at cryogenic and room temperature by Xu, Zebing

    Published 2015
    “…When the temperature decreases, the yield strength, the ultimate tensile strength and ductility to fracture are drastically increased from 217.2 MPa, 252.4 MPa, 14.5% to 251.6 MPa, 335.9 Mpa, 21.5% respectively, and the average diameter of dimples decreases from ~8 µm to ~3 µm. …”
    Get full text
    Get full text
  14. 1174
  15. 1175

    Perinatal outcomes following Helping Babies Breathe training and regular peer-peer skills practice among village midwives in Sudan. by Arabi, Ame

    Published 2017
    “…Excluding 11 macerated fetuses, there were 55 perinatal deaths: 14 FSB/18 ENND (6 months pre-HBBT(+RPPSP)) and 10 FSB/13 ENND (18 months post-HBBT(+RPPSP)). FSB rates decreased from 10.5 to 3.3 per 1000 births ((χ(2))=8.6209, p=0.003), while ENND rates decreased from 13.5 to 4.3 per 1000 live births ((χ(2))=10.9369, p=0.001) pre-HBBT(+RPPSP) and post-HBBT(+RPPSP), respectively. …”
    Get full text
    Get full text
  16. 1176

    Control of the antagonistic effects of heat-assisted chlorine oxidative degradation on pressure retarded osmosis thin film composite membrane surface by Ralph Rolly, Gonzales

    Published 2021
    “…The chlorine oxidative degradation is optimized in terms of chlorine exposure (a factor of both exposure time and chemical dosage), solution pH, and the subsequent heating time. …”
    Get full text
    Get full text
    Get full text
  17. 1177

    Shear Behavior of Green Concrete Beams Reinforced with Basalt FRP Bars and Stirrups. by Elahtem, Ayman Ahmed

    Published 2020
    “…The parameters investigated in this study are span to depth ratio (i.e. a/d =2.5 and 3.5), reinforcement ratio , stirrups spacing effect (i.e. 250 mm and 350 mm) and stirrups type (Steel and Basalt). …”
    Get full text
  18. 1178
  19. 1179

    Sensitization to common food and inhalant allergens in children attending Allergy and Asthma Pediatric Clinic in Doha, Qatar by Kerkadi, Abdelhamid

    Published 2009
    “…The prevalence of sensitization to FA decreased as age increases (35% at 0-2 years vs. 32.5% at the age 6-10 years). …”
    Get full text
    Get full text
  20. 1180

    Foamed phase change materials based on recycled polyethylene/paraffin wax blends by Sobolčiak, Patrik

    Published 2021
    “…Differential Scanning Calorimetry was used to determine the specific enthalpies of melting (22.4–25.1 J/g) what is the latent heat of materials utilized during a heat absorption. A stability of samples during 10 heating/cooling cycles was demonstrated. …”
    Get full text
    Get full text