HSF2 reduced the decrease in the MMP in Caco-2 cells, which were observed by laser confocal microscopy. by Wen Wang (6570)

“…Red fluorescence indicated that there was no obvious abnormality in the MMP, while green fluorescence represented a decrease in the MMP. B: Statistical bar chart of the ratio of red to green fluorescence, <i>P</i> value of less than 0.05 was identified as* and <i>P</i> value of less than 0.01 was identified as**. …”

BA attenuated the decrease in the expression of ZO-1 and Occludin induced by LPS in Caco2 cells. by Luqiong Liu (11537092)

BA attenuated the decrease in the integrity and increase in the permeability of the epithelial barrier injury induced by LPS in Caco2 cell monolayers. by Luqiong Liu (11537092)

“…<p>(<b>A)</b> Changes in TEER with increasing culture time on days 1–22. …”

Y-27632 collaborated with BA to attenuate the increase in the integrity and decrease in the permeability of epithelial barrier injury induced by LPS in Caco2 monolayers. by Luqiong Liu (11537092)

“…<p>(<b>A)</b> Y-27632 collaborated with BA to attenuate the effect of LPS on TEER in Caco2 cells on days 1–22. …”

Y-27632 synergized with BA to alleviate the decrease in the expression of and abnormal localization of ZO-1 and Occludin in LPS-induced Caco2 cells. by Luqiong Liu (11537092)

Transepithelial resistance of NHBE decreases significantly after PAA exposure. by Ellie S. Burns (21246537)

PMC exhibits less sensitivity to decreasing signal-to-noise ratio (SNR) by Owen Puls (22340344)

Macrophage-specific IGF-1 overexpression decreases plaque MMP8 and. by Patricia Snarski (22305205)

Particle size distribution curve (a) and XRD pattern (b) of standard siliceous sand. Particle size distribution of the standard siliceous sand was measured using a laser particle s... by Liang Xiong (1426411)

Uncropped blots corresponding to Fig 3A, provided for assessment of band specificity and loading consistency. by Tetsuya Kakita (4922584)

Ethnic identity as a moderator among APIDA students. by Ronna Bañada (19233063)

Apoptosis inhibitor prevented the decrease of IIL ESP-induced TJs expression and alleviated barrier disruption of Caco-2 monolayer. by Qi Qi Lu (17721401)

“…<p><b>A:</b> Apoptosis inhibitor Z-VAD-FMK pretreatment increased the IIL ESP-decreased TEER. …”

Infrared Matrix-Assisted Laser Desorption Electrospray Ionization (IR-MALDESI) Mass Spectrometry Imaging of Per- and Polyfluoroalkyl Substances (PFAS) in Stabilized Soil Cores by Theresa Guillette (20893712)

“…Previous field-scale research demonstrated a substantial decrease in the leachability of PFAS following the application of in situ stabilization and solidification (S/S) in an aqueous film-forming foam (AFFF) source zone. …”

SEM morphology of power: (a)17−4PH; (b)TiC. by Dian Yu Luo (22656111)

“…Field tests showed that the laser-cladded blades maintained a relatively sharp edge even after harvesting wheat for 120 h, whereas the commercially available heat-treated blades had completely failed. …”

The effect of HA digestion and HA replenishment alone or with CS on barrier function measured by TEER. by Charlotte J. van Ginkel (20790466)

“…<p>(A) A steady increase in TEER is seen in differentiated porcine urothelial cells, corresponding with a tight epithelium and reaching the upper reliable limit of the equipment (3300 Ω cm²) around day 35. …”

Laser-Enhanced Bubble Detachment Velocity and Heat Dissipation on Abrasive Surfaces by Cong He (5074154)

“…It was discovered that the bubble detachment velocity initially increases and subsequently decreases with increasing laser power density, while a reduction in surface roughness can enhance the detachment velocity. …”

Laser-Enhanced Bubble Detachment Velocity and Heat Dissipation on Abrasive Surfaces by Cong He (5074154)

“…It was discovered that the bubble detachment velocity initially increases and subsequently decreases with increasing laser power density, while a reduction in surface roughness can enhance the detachment velocity. …”

Laser-Enhanced Bubble Detachment Velocity and Heat Dissipation on Abrasive Surfaces by Cong He (5074154)

“…It was discovered that the bubble detachment velocity initially increases and subsequently decreases with increasing laser power density, while a reduction in surface roughness can enhance the detachment velocity. …”

Laser-Enhanced Bubble Detachment Velocity and Heat Dissipation on Abrasive Surfaces by Cong He (5074154)

“…It was discovered that the bubble detachment velocity initially increases and subsequently decreases with increasing laser power density, while a reduction in surface roughness can enhance the detachment velocity. …”

Laser-Enhanced Bubble Detachment Velocity and Heat Dissipation on Abrasive Surfaces by Cong He (5074154)

“…It was discovered that the bubble detachment velocity initially increases and subsequently decreases with increasing laser power density, while a reduction in surface roughness can enhance the detachment velocity. …”