Tobacco Use and Its Health Effects among Professional Athletes in Qatar by Chaabane, Zaina

“…The objective of the study was to determine the effects of tobacco use on selected markers of health and lung function in professional athletes. A total of 108 male professional athletes participated in the study from ten ball game teams in the same sport league in Qatar (age = 26.4 ± 5.1 yrs, height = 190.6 ± 11.9 cm, and weight = 91.5 ± 16.4 kg). …”
Get full text
Get full text

Shear Behavior of Green Concrete Beams Reinforced with Basalt FRP Bars and Stirrups. by Elahtem, Ayman Ahmed

“…The parameters investigated in this study are span to depth ratio (i.e. a/d =2.5 and 3.5), reinforcement ratio , stirrups spacing effect (i.e. 250 mm and 350 mm) and stirrups type (Steel and Basalt). …”
Get full text

Assessment of Urban Heat Islands Based on the Relationship Between Land Surface Temperature and Land Use/Land Cover in Greater Doha by Siddiqui, Simil Amir

“…Furthermore %LULC of built up, vegetation, barren land, marsh land and water body were 29%, 4.5%, 58.6%, 2.8% and 5% in 2000 and 56.5 %, 8.2%, 33.2 %, 0% and 2.1% in 2019 respectively. …”
Get full text
Get full text

Study the efficiency of Ultrasonic Technology in Removal of Algae from Surface Waters by Maarouf, Alaa

“…The dominant algae genus was identified using a light microscope, and ultrasound waves with a low frequency of 40 kHz and a power density of 0.024 W/cm³ were applied at different time intervals (0 – 80 minutes) at time intervals of 5 minutes. …”
Get full text

Magnetorheological damper with external excitation for more efficient control of vehicles? dynamics by Sassi S.

“…The experimental tests made on the first prototype featuring this new technology was promising. The excitation of a set of 12 coils surrounding the body of the damper, by an electric current of 5 A, managed to increase the damping coefficient by up to 75%. …”
Get full text
Get full text

Experimental investigation of the influence of grain geometry on residual NAPL using synchrotron microtomography by Al-Raoush, Riyadh I.

Get full text
Get full text

Impact of combined oil-in-water emulsions and particulate suspensions on ceramic membrane fouling and permeability recovery by Abdalla M.

“…The addition of 1500 mg·L−1 of bentonite to a 10 vol.% emulsion resulted in a permeability decrease of 3.5–5 times over that recorded for the emulsion, and 8–36 times lower than that of the bentonite suspension. …”
Get full text
Get full text

Phase change materials based on high-density polyethylene filled with microencapsulated paraffin wax by Krupa, Igor

Get full text
Get full text

Effect of mobile text messages on antiretroviral medication adherence and patient retention in early HIV care: An open-label, randomized, single center study in south Florida by Sherman, Elizabeth M.

“…A significant increase in CD4 cell count and a decrease in HIV RNA were found at study end, with no differences between the two groups. …”
Get full text
Get full text

High-Rate Anaerobic Digestion of Waste Activated Sludge by Integration of Electro-Fenton Process by Feki, Emna

“…Production of biogas was also found to improve during semi-continuous fermentation of EF-pretreated sludge conducted in a lab-scale reactor. In comparison to raw sludge, EF-pretreated sludge produced the highest biogas yield (0.81 L biogas/g VS) with a high COD removal rate, reaching 96.6% at an organic loading rate (OLR) of 2.5 g VS/L. d. …”
Get full text
Get full text

Effect of electroless bath composition on the mechanical, chemical, and electrochemical properties of new NiP-C 3 N 4 nanocomposite coatings by Fayyad E.M.

“…An electroless bath of 0.5 g L−1 C3N4 offered a nanocomposite coating with the highest microhardness and superior corrosion resistance. …”
Get full text
Get full text

Thermodynamic analysis of solar-driven chemical looping steam methane reforming over Cr2O3/Cr redox pair by Bhosale, Rahul

“…The total solar energy required to drive the CS process (Q-solar-CS) rises by 1498.8 kW as the CH4/Cr2O3 molar ratio upsurges from 0.5 to 3. In case of the CSH process, when the TL increases from 500 to 1400 K, the Q solar CSH decreases by 54.5 kW and further surge in the TL from 1400 to 2050 K yields into upturn in the Q-solar-CSH by 108.5 kW. …”
Get full text
Get full text

Conceptual Framework for Planning Urban Roadside Vegetation to Enhance Air Quality for Roadside Users by Mogra, Soujanya

Get full text
Get full text

The Interference of Notch1 target Hes1 affects cell growth, differentiation and invasiveness of glioblastoma stem cells through modulation of multiple oncogenic targets by Cenciarelli, Carlo

“…Herein, we report that exposure to a Stat3/5 inhibitor, induced apoptosis either in shHes1-CSC or control cells. …”
Get full text

Food shopping, preparation and consumption practices in times of COVID-19: case of Lebanon by Ben Hassen, Tarek

“…Indeed, the study outcomes suggested (1) a move toward healthier diets; (2) a rise in the consumption of domestic products due to food safety concerns; (3) a change in the grocery shopping behaviors (with a rise in online shopping); (4) a surge of food stockpiling; and (5) a decrease in household food wastage. …”
Get full text
Get full text

Flexural Capacity of Sustainable RC Beams Manufactured with Treated Wastewater, RCA, and Fly Ash by Abushanab, Abdelrahman

“…Furthermore, FA showed a 5% to 7% improvement in the ultimate loading capacity of the beams.…”
Get full text
Get full text

Effect of Hyperglycemia on eNOS function in EPCs by Elshiekh, Duaa Ibnomer

“…Results showed that both acute and chronic hyperglycemia showed a trend towards decrease in phosphorylation of eNOS and Akt. …”
Get full text
Get full text

Experimental study on effective placement of PCM packets in cooling vest to improve performance in warm environment by Itani, Mariam

“…The used PCM melting temperature is 28 °C with a coverage area of 642 cm2 and total weight of the vest of 1.19 kg including 8 PCM packets (87.5 grams each). …”
Get full text
Get full text

Enhancing the UV/heat stability of LLDPE irrigation pipes via different stabilizer formulations by Porfyris, Athanasios D.

Get full text
Get full text

Numerical investigation of steady air injection flow to control rotating stall in centrifugal compressors by Halawa, Taher

“…Numerical model was built to simulate high speed transonic centrifugal compressor working at an operating point close to surge. Air was injected at 12 locations at the vaneless region between the impeller and the diffuser at shroud surface with 5 different injection angles and 3 different injection mass flow rates. …”
Get full text
Get full text
Get full text