-
1
Understanding the False Positive of Modified Martensitic Steels in Sweet & Sour Service Conditions Using a Point Defect Model Perspective
Published 2023“…These results indicate a critical point in temperature in the tests with only CO2, where resistance to pitting susceptibility is maximized due to a decrease in the cation vacancy diffusivity.…”
Get full text
-
2
Effect of octylphenol polyethylene oxide on the corrosion inhibition of steel in 0.5 M H2SO4
Published 2004“…A non-ionic surfactant, octylphenol polyethylene oxide (OPPEO), was evaluated as an inhibitor for corrosion of low-carbon steel in 0.5M H 2SO4. Potentiodynamic and potentiostatic methods and scanning electron microscopy were used to study the inhibition effectiveness of the surfactant. …”
Get full text
Get full text
-
3
-
4
An Eco-Friendly Quaternary Ammonium Salt as a Corrosion Inhibitor for Carbon Steel in 5 M HCl Solution: Theoretical and Experimental Investigation
Published 2022“…The overall results revealed that adding varied concentrations of Q-22 significantly decreases the corrosion rate of C-steel. The results revealed the physisorption nature of Q-22 onto the C-steel surface, with adsorption following the Freundlich isotherm (∆Hads = −16.40 kJ·mol−1). …”
Get full text
Get full text
-
5
Design and analysis of PV fed high-voltage gain DC-DC converter using PI and NN controllers
Published 2022“…Here, 48 V is doubled to 400 V. By modifying the converter's parameters, its behavior is evaluated. …”
Get full text
Get full text
Get full text
article -
6
Opportunities, challenges and trade-offs with decreasing avoidable food waste in the UK
Published 2021“…Stakeholder interrelations, regulatory and socio-economic aspects are discussed in relation to their influence on decreasing avoidable food waste. The main output from this work is a diagrammatic depiction of where challenges and trade-offs occur along the food supply chain, and how policy and socio-economic reforms are needed to maximise avoidable food waste prevention, and the surplus avoidable food redistribution in the food supply chain for social benefit.…”
Get full text
Get full text
Get full text
-
7
A new family of boost active neutral point clamped inverter topology with reduced switch count
Published 2021“…A new family of inverter topology for active neutral point clamped (ANPC) is proposed. …”
Get full text
Get full text
-
8
Turning point in COVID-19 severity and fatality during the pandemic: a national cohort study in Qatar
Published 2023“…Conclusion The conclusion of the first omicron wave was a turning point in the severity of the pandemic. …”
Get full text
Get full text
-
9
Impact of magnetic dipole on a thermally stratified ferrofluid past a stretchable surface
Published 2019“…This article focuses on the characteristics of a magnetic dipole in a viscous ferrofluid induced by linear stretched surface. …”
Get full text
Get full text
-
10
Hyperhydration-induced decrease in urinary luteinizing hormone concentrations of Male athletes in doping control analysis
Published 2019“…Baseline urinary LH concentrations, expressed as the mean � SD for each individual, were within the acceptable physiological range (7.11 � 5.42 IU/L). …”
Get full text
Get full text
-
11
Electrochemical behavior of mild and corrosion resistant concrete reinforcing steels
Published 2020“…Extensive analysis of the results indicates that the corrosion resistance of the evaluated steels was in the following decreasing order: EC, HC, MS, and HS.…”
Get full text
Get full text
-
12
A robust experimental-based artificial neural network approach for photovoltaic maximum power point identification considering electrical, thermal and meteorological impact
Published 2020“…Nonetheless, the consideration of irradiance, electrical, thermal, and weather parameters (scenario IV) yielded higher identification accuracy. The results showed a decrease in the MSE of Vmp by 74.3% (from 1.6 V to 0.411 V), and in the MSE of Imp by 95% (from 4.4e−6 A to 2.16e−7 A), respectively. …”
Get full text
Get full text
Get full text
-
13
Multifunctional self-healing polymeric nanocomposite coatings for corrosion inhibition of steel
Published 2020“…The electrochemical studies indicate that the corrosion rate of the steel samples coated with the epoxy modified with the healing additives decreases after 5 days of immersion in saline water.…”
Get full text
Get full text
-
14
Multifunctional self-healing polymeric nanocomposite coatings for corrosion inhibition of steel
Published 2019“…The electrochemical studies indicate that the corrosion rate of the steel samples coated with the epoxy modified with the healing additives decreases after 5 days of immersion in saline water.…”
Get full text
Get full text
-
15
Development And Performance Evaluation Of Smart Polymeric Coatings For Corrosion Protection Of Steel
Published 2020“…Consequently, they are a promising solution for longer durability of coated piping steel and decreased operation expense. If properly designed, smart self-healing coatings also help to reduce the overall thickness of the coating scheme as well as the investment cost. …”
Get full text
-
16
Corrosion behavior of API X100 steel material in a hydrogen sulfide environment
Published 2017“…The results indicate that the corrosion rate of API X100 steel decreases with increasing H2S bubbling time due to the increase in H2S concentration in 3.5% NaCl solutions. …”
Get full text
Get full text
-
17
-
18
Simulation and experimental study of underwater dissimilar friction-stir welding between aluminium and steel
Published 2020“…Theeffects of processing parameters on the formation of intermetallic compounds (IMCs) atthe Al/St interface, microstructural characteristics, and mechanical property of dissimilarweldments were studied and addressed. By decreasing tool rotational speed (w), increas-ing traverse velocity (v), and employing cooling medium, peak temperature continuouslyreduced (down to ?…”
Get full text
Get full text
-
19
Enhancing the corrosion resistance of reinforcing steel under aggressive operational conditions using behentrimonium chloride
Published 2019“…In conclusion, this new inhibitor shows high corrosion inhibition efficiencies under different aggressive conditions and can be used in concrete to reduce the corrosion rate of reinforcing steel without decreasing the mechanical properties of the concrete. - 2019, The Author(s).…”
Get full text
Get full text
-
20
