Assessment of SnO2 nanoparticles' impact on local Pichoclorum atomus growth performance, cell morphology and metabolites content by Bounnit, Touria

“…The current study investigates the ecotoxicity of SnO2 nanoparticles on a local marine algae isolate. Five different concentrations (1, 5, 25, 50 and 100mg/L) were tested and the culture was followed for 72h. …”
Get full text
Get full text

Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

“…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
Get full text

Synthesis and characterization of stir casted Cu-ZrO2-Graphite hybrid metal matrix composites for thermal management structures by Mittal, Prateek

“…ZrO2 and Graphite reinforcements were added (0.5–0.5, 1.0–1.0, 1.5–1.5 and 2.0–2.0 wt %) in the four composite samples prepared via stir casting. …”
Get full text
Get full text
Get full text

Prevalence of vincristine induced-peripheral neuropathy among Sudanese cancer patients by Imam, Ethar Abdelmageed

“…Healthcare professionals need some understanding regarding medical management that may decrease occurrence of neuropathy and a better planning and implementing special care for patients at risk.…”
Get full text
Get full text

Superior photocatalytic activity of Cu doped NiWO4 for efficient degradation of benzene in air even under visible radiation by Tri N.L.M.

“…This was because Cu effectively acted as novel dopant, which not only affected valence band (VB) top and conduction band (CB) bottom of NiWO4 but also formed a medium energy level between CB and VB of the NiWO4 to decrease its energy band gap and electron-hole recombination rate. …”
Get full text
Get full text

Structural influence of chromium substituted magnetite ferrofluids on the optical and antibacterial characteristics by Babukutty, B.

“…As the composition of Cr increases from x = 0.2 to x = 0.8, the crystalline size decreases reaching a minimum value of 9 nm. At the same time, the magnetic moment also becomes 1.3 +- 0.08 at a saturation point of 33 +- 0.13 emu/g at the highest Cr composition. …”
Get full text
Get full text

Hypospadias Reconstruction Training: Development of an Ex-Vivo Model for Objective Evaluation of Surgical Skills by Abbas, Tariq

“…However, EMG measurements showed significant reductions in average EMG power, total time, dominant frequency, and cumulative muscle workload after training. Additionally, the mean power spectral density of the EMG signal decreased notably post-training. …”
Get full text
Get full text
Get full text

Improvement of both lipid and biomass productivities of Qatar Chlorocystis isolate for biodiesel production and food security by Saadaoui, Imen

“…Most previous research evidenced that the increase of the lipid content is accompanied by a decrease of the biomass production, which increases the cost of the downstream processing. …”
Get full text
Get full text

Recycled Polypropylene Fibres for Reinforcing Cement Mortar under Arid Conditions by Bendjillali, Khadra

Get full text
Get full text

Short-term greenhouse emission lowering effect of biochars from solid organic municipal wastes by Rehrah D.

“…A significant decrease in CO2 emission was observed in vials with soil–biochar mixtures, especially for biochars produced at 500 °C compared the corresponding raw materials which exhibited an exponential increase in the CO2 emission. …”
Get full text
Get full text

Influence of shelf-life duration on mechanical, thermal and shape recovery motion derivatives of shape memory polyurethane by Vasavi, Boggarapu

“…In addition, Differential scanning calorimetry (DSC)exhibited a decrease in glass transition temperature (Tg) from S1 to S10, resulting in a corresponding reduction in the rate of shape restoration. …”
Get full text
Get full text
Get full text

Battery-Induced Load Hiding and Its Utility Consequences by Aly, Hussein

“…Our findings reveal that the inclusion of battery users in datasets can diminish the quality of conclusions drawn from these data. This can result in a decrease in the Area Under the Curve (AUC) by more than 10% when attempting to profile users within single-occupant and multiple-occupant households. …”
Get full text
Get full text

Modeling of dual-metal Schottky contacts based silicon micro and nano wire solar cells by Rabbani, M. Golam

Get full text
Get full text

Electrospun polylactic acid/date palm polyphenol extract nanofibres for tissue engineering applications by Khadija M., Zadeh

“…Increasing the polyphenol concentration caused the tensile strength and Young’s modulus to decrease. The SEM graphs indicated a decrease in fibre diameter with increasing DP content. …”
Get full text
Get full text

Trilemma of life cycle carbon, employment, and costs of trucking industry's shift toward automation and electrification by Mandouri, Jafar

“…Autonomy and electrification combined could lead to a 50% decrease in emissions and 46% savings in life cycle costs. …”
Get full text
Get full text

Undrained interface shear strength of fine-grained soils for near-shore marine pipelines by Eid, Hisham T.

“…The peak and residual interface shear strengths for a variety of normally consolidated soils were measured using a torsional ring shear apparatus modified to suit soil and interface testing under the undrained condition, which is usually prevalent at soil-marine pipeline interfaces. …”
Get full text
Get full text

Structural and electrochemical properties of electrodeposited Ni-P nanocomposite coatings containing mixed ceramic oxide particles by Zadeh, K.M.

Get full text
Get full text

Unlocking the application potential of electrocoagulation process through hybrid processes by Almukdad, Abdulkarim

Get full text
Get full text

An Overview of Solid Waste Management and Plastic Recycling in Qatar by Al-Maaded, M.

“…The analysis showed that Qatar produced around 2,000,000 tons of solid municipal waste annually, corresponding to a daily generation rate per capita of about 2. 5 kg. …”
Get full text
Get full text

Interface modification of compatibilized polyethylene terephthalate/polypropylene blends: Effect of compatibilization on thermomechanical properties and thermal stability by Inuwa, Ibrahim M.

“…PET, PP, and SEBS-g-MAH were melt-blended in a single stLGusing the counter rotating twin screw extruder with compatibilizer concentrations of 0, 5, 10, and 15 phr, respectively. …”
Get full text
Get full text