Carbon nanotube effect on the ductility, flexural strength, and permeability of concrete by Mohsen, Mohamed O.

“….% CNTs were prepared using a mixing method that consisted of a 30-minute solution sonication and a 60-minute batch mixing. …”
Get full text
Get full text

Wound healing potential of quercetin-3-O-rhamnoside and myricetin-3-O-rhamnoside isolated from Pistacia lentiscus distilled leaves in rats model by Elloumi, Wiem

“…Moreover, MM, and QM induced a good elastase inhibition at 100 µg/ml compared to the standard epigallocatechin gallate. …”
Get full text
Get full text
Get full text

The Role of Key Impurity Elements on the Performance of Aluminium Electrolysis - Current Efficiency and Metal Quality by Al-Mejali, Jassim Ali

“…It is established in the literature that for every 100 ppm of phosphorus in the bath the current efficiency is decreased by 1%. …”
Get full text

Correlation of multiple time-scale and uncertainty modelling for renewable energy-load profiles in wind powered system by Mehrjerdi H.

“…But they increase the simulation time about 100, 200, and 300%, respectively. As a result, 15-min time-scale is considered as the best case because it keeps both simulation time and model accuracy on the acceptable level. …”
Get full text
Get full text

Electrochemical Investigation of C-Steel Corrosion Inhibition, In Silico, and Sulfate-Reducing Bacteria Investigations Using Pyrazole Derivatives by Shaban, Mahmoud M.

“…The compounds under investigation were adsorbed on a C-steel surface in 1 M HCl following the Langmuir isotherm model. …”
Get full text
Get full text

Modified zno nanoparticles using iron ions (Fe3+) for photo-catalytic degradation of toxic pollutants under sunlight by Ba-Abbad, Muneer M.

“…As the Fe3+ concentration increased from 0.25 to 1.00 wt. %, the crystal size decreased in comparison with the undoped ZnO. …”
Get full text

Synthesis and electrochemical properties of nickel oxide/carbon nanofiber composites by Al-Enizi, Abdullah M.

“…The EDLC increased from 0.144 F g−1 at a calcination temperature of 100 °C to 485 F g−1 at a calcination temperature of 500 °C.…”
Get full text
Get full text

Facile Electrochemical Synthesis of Highly Efficient Copper-Cobalt Oxide Nanostructures for Oxygen Evolution Reactions by Nath, Narayan Chandra Deb

“…An optimized nanopetal structure of CuxCo3-xO4 (x = 0.95, annealed at 200 °C) shows a considerably high Faradaic efficiency (∼93%) with a remarkably low overpotential (∼230 mV) at a benchmark current density (J) of 10 mA cm-2; at the same J in an alkaline solution (1 M KOH) for OER, it also exhibits high durability (up to 100 h). …”
Get full text
Get full text
Get full text

Centrifugal Compressor Spiral Dry Gas Seal Simulation Working at Reverse Rotation by Ibrahim, Shahin

“…The open force corresponding to reverse rotation increased with a value 1.5kN for both the 100 overlap and 50% forward overlap seal faces, but using seal face with 50% backward overlap failed to enhance the open force at reversal condition.…”
Get full text
Get full text
Get full text

Thermochemical splitting of CO2 using solution combustion synthesized lanthanum-strontium-anganese perovskites by Takalkar, G.

“…Redox reactivity of La(1-x)SrxMnO3 (LSM) perovskites towards a solar thermochemical CO2 splitting (CS) cycle is investigated. …”
Get full text
Get full text

Adaptative Network Topology for Data Centers by Chkirbene, Zina

“…It is a topic of high interest and importance for both academia and industry. …”
Get full text
Get full text

Olive Leaves Extract and Oleuropein Improve Insulin Sensitivity in 3T3-L1 Cells and in High-Fat Diet-Treated Rats via PI3K/AkT Signaling Pathway by Hadrich, F.

Get full text
Get full text

Effect of electroless bath composition on the mechanical, chemical, and electrochemical properties of new NiP-C 3 N 4 nanocomposite coatings by Fayyad E.M.

“…The results indicated that the alkaline electroless bath produced a NiP–C3N4 NCC with a microhardness 250 HV200 higher than that produced from the acidic one. …”
Get full text
Get full text

The Separation of Emulsified Water/Oil Mixtures through Adsorption on Plasma-Treated Polyethylene Powder by Abdulkareem, Asma

“…This work addresses the preparation and characterization of efficient adsorbents for tertiary treatment (oil content below 100 ppm) of oil/water emulsions. Powdered low-density polyethylene (LDPE) was modified by radio-frequency plasma discharge and then used as a medium for the treatment of emulsified diesel oil/water mixtures in the concentration range from 75 ppm to 200 ppm. …”
Get full text
Get full text

Functionalization of silica-coated magnetic nanoparticles as powerful demulsifier to recover oil from oil-in-water emulsion by Elmobarak W.F.

“…Increasing the water salinity from 0.1 to 0.5 M slightly improved the %Soil for the tests carried out with a Doil of 100 mg/L to 93.3%, 90.3%, and 86.3% for Fe–Si-2, Fe–Si-3, and FeSi-4, respectively. …”
Get full text
Get full text

Utilization of Two Microalgae Species, Synechococcus sp. and Cheatoceros sp., for Aquatic Toxicity Assessments in the Qatari Marine Environmen by Bacha, Sarah

“…The lowest growth rates were observed at the lowest temperatures, while a decreased rate was also observed at the highest temperature. …”
Get full text
Get full text

Effect of reinforcement concentration on the properties of hot extruded Al-Al2O3 composites synthesized through microwave sintering process by Reddya, M. Penchal

“…Results showed that, as the content of hard ceramic particles increases, it improves overall mechanical properties including microhardness, 0.2% yield strength, ultimate compression/tensile strength, and Young's modulus while the ductility and co-efficient of thermal expansion decreases. XRD patterns and SEM/EDS mapping images show a uniform distribution of Al2O3 particles in the Al matrix. …”
Get full text
Get full text

Bromate reduction by ultraviolet light irradiation using medium pressure lamp by Bensalah, Nasr

“…The observed rate constant (kobs) decreased with increasing bromate concentrations upto 100 μg/L and then it becomes constant at 0.058 min-1 for higher bromate concentrations. …”
Get full text
Get full text
Get full text

Electrochemical and thermodynamic study on the corrosion performance of API X120 steel in 3.5% NaCl solution by Shahzad, Khuram

“…The overall results revealed that PEI significantly decreases the corrosion rate of API X120 steel with inhibition efficiency of 94% at a concentration of 100 μmol L−1. …”
Get full text
Get full text
Get full text

Umbelliferone inhibits spermatogenic defects and testicular injury in lead-intoxicated rats by suppressing oxidative stress and inflammation, and improving Nrf2/HO-1 signaling by Alotaibi, Mohammed F.

“…Materials and Methods: Rats received lead acetate (50 mg/kg) and UMB (25, 50 or 100 mg/kg) via oral gavage for 4 weeks. Results: Pb-intoxicated rats exhibited testicular tissue injury and decreased serum levels of LH, FSH and testosterone. …”
Get full text
Get full text
Get full text