Performance of corrosion-aged Reinforced Concrete (RC) beams rehabilitated with Fabric-Reinforced Cementitious Matrix (FRCM) by Elghazy, Mohammed

“…Seven large-scale RC beams were constructed and tested to failure under four-point load configuration. Six beams were subjected to an accelerated corrosion process for 70 days to obtain an estimated mass loss of 10% in the tensile steel reinforcing bars. …”
Get full text

Phase, microstructure and tensile strength of Al–Al2O3–C hybrid metal matrix composites by Ahamad, N.

Get full text
Get full text

Structural and mechanical characterization of stir cast Al–Al2O3–TiO2 hybrid metal matrix composites by Ahamad, N.

Get full text
Get full text

Enhancing thermal and mechanical response of aluminum using nanolength scale TiC ceramic reinforcement by Reddy M.P.

“…the present work, nano-sized titanium carbide (0.5, 1.0 and 1.5 vol%) reinforced aluminum (Al) metal matrix composites were synthesized by powder metallurgy incorporating microwave sintering and hot extrusion. …”
Get full text
Get full text

Food shopping during the COVID-19 pandemic: an exploratory study in four Near Eastern countries by Ben Hassen, Tarek

“…Firstly, respondents decreased their shopping frequency and, as a result, increased the amount of food purchased each trip. …”
Get full text
Get full text
Get full text

ARTIFICIAL INTELLIGENCE TECHNOLOGY IN LARGE-SCALE DATE PALM POLLINATION IN MIDDLE EAST by Al-Mayahi, Al-Moutasim Sulaiman

“…Efficiency was emphasized by 45.8% of respondents, highlighting the need for technological solutions that optimize pollination processes, leading to increased productivity and resource efficiency. Cost was acknowledged by 16.7%, and environmental impact by 37.5%. …”
Get full text

Exploring Beyond Numeric Weight Loss: The Metabolic Effects of Semaglutide. by Sara, Sokary

“…Also, it enhanced glycemic control, as evidenced by significant reductions in hemoglobin A1C (HbA1c) with the 0.5 mg and 1.0 mg doses. From a baseline range of 8.1–8.7%, 0.5mg dose lowered HbA1c by 1.2–1.5%, while the 1.0 mg dose reduced it by 1.4–1.8%. …”
Get full text
Get full text
Get full text

Use and assessment of “e-plastics” as recycled aggregates in cement mortar by Makri, Chrysanthi

“…The obtained results, for all RPs, (especially those of 7.5% and 10%) exhibited an increase in the CS of the specimens by 15.4% and 7.8%, respectively, with the MoE decreased in both cases by 18.1% and 23.8%, respectively. …”
Get full text
Get full text

Fast Prototyping of KNN Based Gas Discrimination System on the Zynq SoC by Ali, Amine Ait Si

“…The system is designed to discriminate five types of gases including C6H6, CH2O, CO, NO2 and SO2 at various concentrations, from 0.25 to 5 parts per million (ppm) for C6H6 and CH2O, from 5 to 200 ppm for CO, from 1 to 10 ppm for NO2 and finally from 1 to 25 ppm for SO2. …”
Get full text
Get full text

Haematological abnormalities and risk of covid-19 infection in adult patients attending primary healthcare settings by Hamed, Ehab

“…Complete blood count of the sample had minimal missing data points. Females were more presented in our samples, Female (n=560, 58.21%) and Male (n=402, 41.79%). …”
Get full text
Get full text
Get full text

Enhancing compressive, tensile, thermal and damping response of pure Al using BN nanoparticles by Penchal Reddy M.

“…The addition of BN nanoparticulates enhanced the damping characteristics of pure Al with Al-1.5 vol.% BN nanocomposite exhibiting the maximum damping capacity and damping loss rate with a minimum change in elastic modulus. …”
Get full text
Get full text

Mixed Solid Municipal Waste-Based Biochar for Soil Fertility and Greenhouse Gas Mitigation by Bansode, Rishipal

“…Municipal solid waste management is one of the major challenges facing Qatar with more than 2.5 million tons of municipal solid waste each year, a very high waste generation rate in a country with small land mass. …”
Get full text
Get full text

Tribological studies of nanomodified mineral based multi-grade engine oil by Laad, M.

“…Wear rate for lubrication oil without nanoadditives was also found to be decreased with increase in sliding speed. Experimental results prove that nanoparticles can be used as a multifunctional additive in lubricating oil to enhance its tribological properties.…”
Get full text
Get full text

Effects of Turbulence Intensity and Biogas Composition on the Localized Forced Ignition of Turbulent Mixing Layers by d’Auzay, C. Turquand

Get full text
Get full text

Impact of composition and salinity on swelling and gel strength of poly (acrylamide-co-acrylic acid) preformed particle gel by Ben Ali, Ahmed

“…On the contrary, PPG5, with the lowest acrylic acid and highest crosslinker content, has a swelling capacity of 239 g/g and more than 17 g/g in distilled and brine 1, respectively. …”
Get full text
Get full text

The Expression of TBC1 Domain Family, Member 4 (TBC1D4) in Skeletal Muscles of Insulin-Resistant Mice in Response to Sulforaphane by Rizk, Nasser M

“…Background: Obesity is commonly accompanied by impaired glucose homeostasis. Decreased glucose transport to the peripheral tissues, mainly skeletal muscle, leads to reduced total glucose disposal and hyperglycemia. …”
Get full text
Get full text

Qatarization success Factors: A framework for organizations and policymakers by Al-Homsi, Bisher M. Osama

“…Responding to the rapidly increasing business activity, an influx of expatriate workers has been filling the gap between the limited supply and the large demand of skilled and unskilled workers. …”
Get full text

Biological Pathways Associated With the Development of Pulmonary Toxicities in Mesothelioma Patients Treated With Radical Hemithoracic Radiation Therapy: A Preliminary Study. by Crovella, Sergio

Get full text
Get full text

Modeling the influence of daily temperature and precipitation extreme indices on vegetation dynamics in Katsina State using statistical downscaling model (SDM) by Mohammad, Hadi Ahmad

“…All the scenarios present increasing minimum and maximum temperatures and decreasing precipitation, except for RCP8.5, which predicted a more adverse trend. …”
Get full text
Get full text
Get full text

Enhanced performance of nano-sized SiC reinforced Al metal matrix nanocomposites synthesized through microwave sintering and hot extrusion techniques by Reddy, M. Penchal

“…In the present study, nano-sized SiC (0, 0.3, 0.5, 1.0 and 1.5 vol%) reinforced aluminum (Al) metal matrix composites were fabricated by microwave sintering and hot extrusion techniques. …”
Get full text
Get full text