HSF2 reduced the decrease in the MMP in Caco-2 cells, which were observed by laser confocal microscopy. حسب Wen Wang (6570)

Laser Induced Shockwave to Study Cell Injury حسب Xindong Zheng (22435458)

"…Shockwaves were used to simulate mechanical stress and induce cell death, with a focus on the role of lysosomal enzyme Cathepsin B. Acridine orange staining revealed that cells closest to the shockwave epicenter experienced the greatest decrease in lysosomal intensity, indicating degradation.…"

Particle size distribution curve (a) and XRD pattern (b) of standard siliceous sand. Particle size distribution of the standard siliceous sand was measured using a laser particle s... حسب Liang Xiong (1426411)

Data: S. Sasaki <i>et al</i>., Dalton Trans. <b>54</b>, 1521-1527 (2025). DOI: 10.1039/D4DT03214D حسب Satoshi Sasaki (21090340)

SEM morphology of power: (a)17−4PH; (b)TiC. حسب Dian Yu Luo (22656111)

الموضوعات:

Schematic eye for LIO-ROP training and practice. حسب Narisa Rattanalert (21445983)

الموضوعات:

PMC exhibits less sensitivity to decreasing signal-to-noise ratio (SNR) حسب Owen Puls (22340344)

(a) The installation method of blade holder, (b) Blades in operation, (c) The blade after 120h of wheat harvesting. حسب Dian Yu Luo (22656111)

الموضوعات:

Macrophage-specific IGF-1 overexpression decreases plaque MMP8 and. حسب Patricia Snarski (22305205)

Supporting Information_RIN.xlsx حسب Weichao Wang (22114933)

"…<p dir="ltr">Relative intensity noise (RIN) is another important characteristic of single-frequency lasers.</p><p dir="ltr">Without additional noise suppression mechanisms, typical RIN levels are in the range of −120 to −130 dB/Hz 24]. …"

SEM morphology and EDS surface-scanning energy spectra of 17-4PH-xTiC coated abrasion marks: (a) 10%TiC; (b) 20%TiC; (c) 30%TiC; (d) 40%TiC. حسب Dian Yu Luo (22656111)

الموضوعات:

Ultrasmooth Micromilling of Stainless Steel by Ultrashort Pulsed Laser Ablation Using MHz Bursts حسب Xiao Jia (1703719)

"…A two-dimensional model has been developed to unveil the fundamental thermodynamic process and evolution of ablation and melting in material during USP laser burst ablation. Compared to single-pulse ablation, the optimum ablation efficiency decreases with increasing PpB by less than 30% in burst ablation. …"

3a and 3b show SEM images of the PA-12 and PC powder mixture. حسب Saleh Ahmed Aldahash (16441937)

الموضوعات:

Laser-Enhanced Bubble Detachment Velocity and Heat Dissipation on Abrasive Surfaces حسب Cong He (5074154)

"…It was discovered that the bubble detachment velocity initially increases and subsequently decreases with increasing laser power density, while a reduction in surface roughness can enhance the detachment velocity. …"

Laser-Enhanced Bubble Detachment Velocity and Heat Dissipation on Abrasive Surfaces حسب Cong He (5074154)

"…It was discovered that the bubble detachment velocity initially increases and subsequently decreases with increasing laser power density, while a reduction in surface roughness can enhance the detachment velocity. …"

Laser-Enhanced Bubble Detachment Velocity and Heat Dissipation on Abrasive Surfaces حسب Cong He (5074154)

"…It was discovered that the bubble detachment velocity initially increases and subsequently decreases with increasing laser power density, while a reduction in surface roughness can enhance the detachment velocity. …"

Laser-Enhanced Bubble Detachment Velocity and Heat Dissipation on Abrasive Surfaces حسب Cong He (5074154)

"…It was discovered that the bubble detachment velocity initially increases and subsequently decreases with increasing laser power density, while a reduction in surface roughness can enhance the detachment velocity. …"

Laser-Enhanced Bubble Detachment Velocity and Heat Dissipation on Abrasive Surfaces حسب Cong He (5074154)

"…It was discovered that the bubble detachment velocity initially increases and subsequently decreases with increasing laser power density, while a reduction in surface roughness can enhance the detachment velocity. …"

Effect of laser fluence on reverse saturation current density and carrier mobility in RB–SiC thin films. حسب Praveen Kumar Kanti (21433268)

"…Higher fluence decreases turn-on voltage and increases current (b) Mobility at Electric Field in SiC. …"

Schematic of experimental equipment and process. حسب Dian Yu Luo (22656111)

الموضوعات: