Penalty conversions yield large practical decreases, but robustness and generalizability of result are limited by data quality and sample selection. by Ryan J. Treves (13527735)

Lens profiles as Ez (orange lines) force was increased and Az and Pz (green lines) forces were decreased. by Ronald A. Schachar (16674576)

Expression of lipid biosynthetic genes is decreased with polyamine depletion. by Yazmin E. Cruz-Pulido (20285238)

nsP4-C483Y or Q192L mutations decrease sensitivity to 4′-FlU. by Peiqi Yin (6533747)

The introduction of mutualisms into assembled communities increases their connectance and complexity while decreasing their richness. by Gui Araujo (22170819)

“…(C) Mutualism also promotes an increase in network connectance when introduced into assembled communities, while stopping mutualistic interactions from entering an assembled system slowly decreases it. …”

Percentage of exhale flux penetrating through the mask fabric for different values of <i>c</i>_<i>k</i>; a–c and d–f decreasing porosity for outward and inward protection... by Akshay Anand (118579)

Effective contact rate over time for the different modelling scenarios considered: fixed, continuously increasing, continuously decreasing and with a step-decrease. by Joshua Looker (21390948)

“…<p>Effective contact rate over time for the different modelling scenarios considered: fixed, continuously increasing, continuously decreasing and with a step-decrease.</p>…”

Disturbance of coherent behaviour leads to a decrease in information transfer. by Hannah Zoller (19688084)

Larger example of stimuli with cue relevant for Task 3. by Marcel F. Hinss (14675457)

Flow chart with steps of conducting the study. by Athira Satheesh Kumar (20570553)

“…It is observed that decreasing the number of individual connections does not reduce the size of the rejector population when there are large numbers of messages sent through groups. …”

Flow diagram illustrating the sequence of procedures executed during one time step defined as tick, each of which represents one week. by Alexandra M. Campbell (3284094)

Subjects:

LBM-based approach using synchronous transformation with a time step of 0.43s, PNGM-based method using asynchronous transformation with a 5s time step, VGA using explicit scheme wi... by Mouad Klai (20818364)

Contribution of the through-mask leakages from the cavity and channel network distributed along the periphery of the mask; a–c and d–f are decreasing porosity <i>c</i><sub><i>k</i>... by Akshay Anand (118579)

Polylactic Acid/Polybutylene Adipate Terephthalate-Carbon Nanotube Nanobiocomposites with a Segregated Toughening Morphology Yielding Large Ductility for Biocompatible Materials by Utsab Ayan (18552401)

“…Selective deposition and encapsulation of nanodispersed multiwalled carbon nanotubes (MWCNT) exclusively within polybutylene adipate terephthalate (PBAT) microdomains in a phase-separated microstructure of 80/20 polylactic acid (PLA)/PBAT polymer nanocomposites (PNCs) were achieved by a three-step processing strategy. …”

Includes a file with the results on step parameters. by Sanne Ettema (18786312)

Biases in larger populations. by Sander W. Keemink (21253563)

“…<p>(<b>A</b>) Maximum absolute bias vs the number of neurons in the population for the Bayesian decoder. Bias decreases with increasing neurons in the population. …”

In the first 15 days of pod fill high temperature over 30∘C decreased marketable yield for both seasons. by Miranda Y. Mortlock (20855564)

Comparison of diffusion simulations: implicit scheme of the GDE with a 30-second time step (blue line), implicit scheme of the PNGM with α = 0.6 and a 15-second time step (green li... by Mouad Klai (20818364)

Table of step height. by Jianbo Jia (717814)

“…The simulation results show that for steps of 1mm, 2mm and 3mm height, the optimal polyline angle is concentrated in the range of 10°-11°, in which the Angle of 10.5° has a good performance against the steps of three heights. …”

The well wall step. by Jianbo Jia (717814)

“…The simulation results show that for steps of 1mm, 2mm and 3mm height, the optimal polyline angle is concentrated in the range of 10°-11°, in which the Angle of 10.5° has a good performance against the steps of three heights. …”