An additive manufacturing approach based on electrohydrodynamic printing to fabricate P3HT:PCBM thin films by Zulfikre Esa (19457344)

“…The estimated film mass and thickness were found between 3.235 and 23.471 mg and 597.5 nm to 1.60 µm, respectively. The films exhibited a broad visible absorption spectrum ranging from ~ 340 to ~ 600 nm, with a maximum peak λ_max located at ~ 500 nm. …”

Pilot scale evaluation of thin film composite membranes for reducing wastewater volumes: osmotic concentration process by Abdelrahman M. Awad (16932519)

“…The membrane achieved a water flux of 10 LMH, which slightly decreased to 9.6 after 48 h of operation, mainly due to inorganic scaling. …”

Photostimulation of Phox2b medullary neurons activates cardiorespiratory function in conscious rats by Kanbar, Roy

Get full text
Get full text
Get full text
Get full text

Fixing a heart valve by Nature Research (16552612)

A Multidecadal Assessment of Haze Development and Fluctuations in Visibility for Arabian Peninsula by Luqman Atique (16036586)

“…Visibility in KWT was 0.5 km in 1994, indicating a period of exceptionally poor visibility whereas the daily mean visibility for KSA was approximately 0.6 km. …”

Influence of co-current vapor flow on falling film over horizontal tube by Furqan Tahir (14429547)

“…The average film thickness and wetting time is reduced by 14.1% and 18.5%, respectively for the vapor velocity of 6 m/s compared to the no vapor flow, for 0.02 kg/(m·s). …”

Two-stage optimisation for malachite green removal using activated date pits by M. Hijab (14152095)

“…<p>Water pollution, from industry and agriculture, is a major threat to water security in the light of decreasing global potable water resources. Adsorption is one potential treatment technology for the removal of different contaminants from polluted water. …”

Addressing Challenges of Distance Learning in the Pandemic with Edge Intelligence Enabled Multicast and Caching Solution by Kashif Bilal (16896357)

“…In the scenario of distance learning, there is ample opportunity to realize multi-cast delivery instead of a conventional unicast. However, the existing 5G architecture does not support service-less multi-cast. …”

Influence of temperature on tire-pavement noise in hot climates: Qatar case by Okan Sirin (14603304)

“…This temperature correction factor is developed based on the local environment (temperature varying from 5 °C to 35 °C) and generally varies with different pavements. …”

Algal-algal bioflocculation enhances the recovery efficiency of Picochlorum sp. QUCCCM130 with low auto-settling capacity by Imen Saadaoui (14159025)

“…QUCCCM50 presenting a cell size of ∼2 μm, ∼5 μm, and ∼15 μm, respectively, were selected to be subjected to the harvesting optimisation experiments. …”

Acute intense fatigue does not modify the effect of EVA and TPU custom foot orthoses on running mechanics, running economy and perceived comfort by Ken Van Alsenoy (14150559)

“…Immediately after completion of a repeated-sprints exercise (8 × 5 s treadmill sprints, rest = 25 s), these run tests were replicated. …”

Characteristics of aerosols and planetary boundary layer dynamics during biomass burning season by Muhammad Zeeshaan Shahid (18131689)

“…These elevated pollution levels over NEP (69–75.5°E, 27.4–34°N) are influenced by both meteorological conditions and anthropogenic activities. …”

Evaluation and Enhancement of Triaging Services Through Quality Improvement Tools at Primary Health Care Level: A Clinical Audit Study by Ansif Pallath Majeed (17993848)

“…Compliance with the suggested time target of 5 minutes for physicians to attend medical emergencies has shown a small improvement from 48% at baseline to 55% in the re-audit. …”

Energy conversion of heat from abandoned oil wells to mechanical refrigeration - Transient analysis and optimization by Mohammed Al-Khawaja (17093017)

“…Results show that at realistic and conservative conditions, the geofluid temperature considerably decreases for the first four months of operation (by an average of 30 °C) and tends to be constant after half a year of operation. …”

3D Printing Technology Utilizing Available Construction Materials in the UAE by Ahmed, Sara Khaled

Get full text

Polyaniline Based Composite Membranes for PEM Fuel Cells: Experiments and Factorial Design by Eisa, Ahmed

Get full text

Shear performance of FRP Reinforced Deep Beams Made of Ultra High Performance Concrete (UHPC) by Salman, Omar

Get full text

Green Inhibition of Mild Steel Corrosion in a CO2 Saturated Saline Solution by Gomes, Elron Edgar

Get full text

The Effect of Experimental Recuperative and Appetitive Post-lunch Nap Opportunities, With or Without Caffeine, on Mood and Reaction Time in Highly Trained Athletes by Mohamed Romdhani (9606357)

“…After PSD, POMS score decreased after CAF (<i>p</i> < 0.001; d = 2.38; Δ% = 66.97) and CAF+N20 (<i>p</i> < 0.001; <i>d</i> = 1.68; Δ% = 46.68). …”

Glycemic outcomes of Advanced Hybrid Closed Loop system in children and adolescents with Type 1 Diabetes, previously treated with Multiple Daily Injections (MiniMed 780G system in... by Goran Petrovski (129836)

“…TIR increased from 42.1 ± 18.7% at baseline to 78.8 ± 6.1% in the study phase (p < 0.001). HbA1c decreased from 8.6 ± 1.7% (70 ± 18.6 mmol/mol) at baseline, to 6.5 ± 0.7% (48 ± 7.7 mmol/mol) at the end of the study (<i>p</i> = 0.001). …”