Showing 421 - 440 results of 1,090 for search '(( i e decrease ) OR ( 5 ((((steel decrease) OR (greater decrease))) OR (a decrease)) ))', query time: 0.22s Refine Results
  1. 421
  2. 422

    Contrasting effects of necrotrophic and biotrophic plant pathogens on the aphid Aphis fabae by Al-Naemi, F.

    Published 2013
    “…However, sequential plant infection (pathogens applied 5 days apart) led to a 70% decrease in fecundity and 50% reduction in intrinsic rate of increase. …”
    Get full text
    Get full text
  3. 423

    Development of Internally Pressurized Composite/Metallic/Composite Hybrid Pipes by Alabtah, Fatima Ghassan

    Published 2021
    “…The testing results showed significant improvement in the internal pressure capacity compared to the conventional steel pipes. Fourth, a detailed evaluation of fiber type’s effect on the electrochemical corrosion aspects in different highly corrosive solutions, 0.5 M NaCl, 0.5 M HCl, and 0.5 M H2SO4, was presented. …”
    Get full text
  4. 424

    Shear Behavior of Green Concrete Beams Reinforced with Basalt FRP Bars and Stirrups. by Elahtem, Ayman Ahmed

    Published 2020
    “…The parameters investigated in this study are span to depth ratio (i.e. a/d =2.5 and 3.5), reinforcement ratio , stirrups spacing effect (i.e. 250 mm and 350 mm) and stirrups type (Steel and Basalt). …”
    Get full text
  5. 425

    Anti-Neoplastic Effects of Annonacin against Renal Cell Carcinoma by Munusamy, Shankar

    Published 2016
    “…Results: hour annonacin treatment caused a significant and dose-dependent decrease in the viability of CaKi-2 cells, i.e., 42% in 0.5 ?…”
    Get full text
    Get full text
  6. 426

    Thermally conductive polyethylene/expanded graphite composites as heat transfer surface: Mechanical, thermo-physical and surface behavior by Sobolčiak, Patrik

    Published 2020
    “…This enhanced surface wettability was retained over a long time with only a 9% and 18% decrease in RF and corona plasma-treated samples' surface energy after two months. …”
    Get full text
    Get full text
  7. 427
  8. 428
  9. 429

    Unveiling into Genetic Architecture of Transgenerational Stress Memory via Promoting Drought Tolerance in Barley by Alqudah, Ahmad M.

    Published 2024
    “…A significant quantitative trait nucleotide (QTN) at position 509,466,648 base pairs, has been identified in the candidate gene HORVU.MOREX.r3.5HG0502630. …”
    Get full text
    Get full text
    Get full text
  10. 430

    Effect of Magnetic Baffles and Magnetic Nanofluid on Thermo-Hydraulic Characteristics of Dimple Mini Channel for Thermal Energy Applications by Souayeh, Basma

    Published 2022
    “…The increment changed to 1.82%, 8.16%, and 22.31% for a pitch = 5 mm and 1.01%, 5.96%, and 21.38% for a pitch = 2.5 mm. …”
    Get full text
    Get full text
    Get full text
  11. 431

    Inter-annual variability and distribution of aerosols during winters and aerosol optical thickness over Northeastern Pakistan by Shahid, M. Z.

    Published 2020
    “…ir pollution during winters over north-eastern (NE) Pakistan (71–74.5 E, 28–34 N) is a major challenge that affects human health, climate and daily life. …”
    Get full text
    Get full text
  12. 432

    Effects of soaking, acidity and temperature on cadmium and lead removal from rice by Al-Naimi M.

    Published 2020
    “…Different rice treatments were involved i.e. three soaking times (0, 15, and 30 min), three temperatures (20, 25, and 30 �C) and four concentrations of glacial acetic acid (0.5%, 1%, 2%, and 3%). …”
    Get full text
    Get full text
    Get full text
  13. 433

    Mechanical and microstructure characterization of hard nanostructured N-bearing thin coating by Cabibbo, M.

    Published 2015
    “…The main problem with steel, is that it exhibits a relatively low hardness (below 10GPa) which strongly decreases upon annealing above about 600K. …”
    Get full text
  14. 434

    Structural and electrochemical properties of electrodeposited Ni-P nanocomposite coatings containing mixed ceramic oxide particles by Zadeh, K.M.

    Published 2016
    “…The coatings were electrodeposited on mild steel substrate and were then characterized using various techniques. …”
    Get full text
    Get full text
  15. 435
  16. 436

    Superior photocatalytic activity of Cu doped NiWO4 for efficient degradation of benzene in air even under visible radiation by Tri N.L.M.

    Published 2019
    “…The obtained experimental result indicated that photocatalytic performance of the prepared Cu-NiWO4 materials were greater than that of the pure NiWO4. This was because Cu effectively acted as novel dopant, which not only affected valence band (VB) top and conduction band (CB) bottom of NiWO4 but also formed a medium energy level between CB and VB of the NiWO4 to decrease its energy band gap and electron-hole recombination rate. …”
    Get full text
    Get full text
  17. 437

    Influence of the heteroatom on the optoelectronic properties and transistor performance of soluble thiophene-, selenophene- and tellurophene-vinylene copolymers by Al-Hashimi, Mohammed

    Published 2016
    “…The optical band gap of the polymers is shown to systematically decrease as the size of the heteroatom is increased, mainly as a result of a stabilization of the LUMO energy, resulting in a small band gap of 1.4 eV for P3TeV. …”
    Get full text
    Get full text
  18. 438

    Enzymatic treatment of peanut butter to reduce the concentration of major peanut allergens by Yu, Jianmei

    Published 2013
    “…Treatment of peanut butter with a combination of trypsin and alpha-chymotrypsin resulted in a decrease in IgE-binding, suggesting that enzymatic treatment has the potential to reduce the allergenicity. …”
    Get full text
    Get full text
  19. 439

    Effect of left atrial ligation-driven altered inflow hemodynamics on embryonic heart development: clues for prenatal progression of hypoplastic left heart syndrome. by Salman, Huseyin Enes

    Published 2021
    “…According to our CFD analysis, LAL results in an immediate decrease in the left AV canal WSS levels for 3.5-day (HH21) pre-septated hearts. …”
    Get full text
    Get full text
  20. 440

    High temperature thermal stability of innovative nanostructured thin coatings for advanced tooling by Cabibbo, Marcello

    Published 2014
    “…The main problem with steel, isthat itexhibits a relatively low hardness (below 10 GPa) which strongly decreases upon annealing above about 600 K.Thus, the majority of modern tools are nowadays coated with hard coatings that increase the hardness, decrease the coefficient of friction and protect the tools against oxidation. …”
    Get full text
    Get full text