Roadmap toward energy-positive upfront nitrogen removal process in baseload LNG plant by Mkacher, Hajer

“…The results show that UNrem of 87.5% from the NG feed can reduce the total power requirements by 0.24%, increase the production flow rate by 4.4%, and decrease the exergy losses by 0.23% compared with the base case. …”
Get full text
Get full text

Improvement of both lipid and biomass productivities of Qatar Chlorocystis isolate for biodiesel production and food security by Saadaoui, Imen

“…Most previous research evidenced that the increase of the lipid content is accompanied by a decrease of the biomass production, which increases the cost of the downstream processing. …”
Get full text
Get full text

Recycled Polypropylene Fibres for Reinforcing Cement Mortar under Arid Conditions by Bendjillali, Khadra

Get full text
Get full text

Influence of shelf-life duration on mechanical, thermal and shape recovery motion derivatives of shape memory polyurethane by Vasavi, Boggarapu

“…In addition, Differential scanning calorimetry (DSC)exhibited a decrease in glass transition temperature (Tg) from S1 to S10, resulting in a corresponding reduction in the rate of shape restoration. …”
Get full text
Get full text
Get full text

Control of the antagonistic effects of heat-assisted chlorine oxidative degradation on pressure retarded osmosis thin film composite membrane surface by Ralph Rolly, Gonzales

“…After performing chlorine oxidation at the following optimized conditions: 3025 ppm Cl2·h, pH 10.72, and 3 min heating time, initial non-pressure retarded water flux of 73.2 L m−2 h−1, specific reverse solute flux of 1.17 g L−1, and power density of 18.71 W m−2 (corresponding to water flux of 56.1 L m-2 h-1) at 12 bar were obtained using 0.6 M NaCl as draw and deionized water as feed.…”
Get full text
Get full text
Get full text

Modeling of dual-metal Schottky contacts based silicon micro and nano wire solar cells by Rabbani, M. Golam

Get full text
Get full text

Effects of Trehalose Administration in Patients with Mucopolysaccharidosis Type III. by Mobini, Moein

“…Decreases in mean splenic length were observed, whereas the liver volume did not change. …”
Get full text
Get full text

Kappa-Distributed Electrons in Solar Outflows: Beam-Plasma Instabilities and Radio Emissions by Lazar, M.

Get full text
Get full text
Get full text

Electrospun polylactic acid/date palm polyphenol extract nanofibres for tissue engineering applications by Khadija M., Zadeh

“…Increasing the polyphenol concentration caused the tensile strength and Young’s modulus to decrease. The SEM graphs indicated a decrease in fibre diameter with increasing DP content. …”
Get full text
Get full text

Undrained interface shear strength of fine-grained soils for near-shore marine pipelines by Eid, Hisham T.

“…The peak and residual interface shear strengths for a variety of normally consolidated soils were measured using a torsional ring shear apparatus modified to suit soil and interface testing under the undrained condition, which is usually prevalent at soil-marine pipeline interfaces. …”
Get full text
Get full text

Novel voltage balancing algorithm for single-phase cascaded multilevel inverter for post-module failure operation in solar photovoltaic applications by Rahman S.

Get full text
Get full text

Structural and electrochemical properties of electrodeposited Ni-P nanocomposite coatings containing mixed ceramic oxide particles by Zadeh, K.M.

Get full text
Get full text

Unlocking the application potential of electrocoagulation process through hybrid processes by Almukdad, Abdulkarim

Get full text
Get full text

An Overview of Solid Waste Management and Plastic Recycling in Qatar by Al-Maaded, M.

“…The analysis showed that Qatar produced around 2,000,000 tons of solid municipal waste annually, corresponding to a daily generation rate per capita of about 2. 5 kg. …”
Get full text
Get full text

Interface modification of compatibilized polyethylene terephthalate/polypropylene blends: Effect of compatibilization on thermomechanical properties and thermal stability by Inuwa, Ibrahim M.

“…PET, PP, and SEBS-g-MAH were melt-blended in a single stLGusing the counter rotating twin screw extruder with compatibilizer concentrations of 0, 5, 10, and 15 phr, respectively. …”
Get full text
Get full text

Correlating the rheological and magneto-optical properties of cobalt substituted magnetite ferrofluids (CoxFe1?xFe2O4) with theoretical studies by Babukutty, B.

Get full text
Get full text

Differences in the neovascular potential of thymus versus subcutaneous adipose-derived stem cells from patients with myocardial ischemia. by Oliva-Olivera, Wilfredo

Get full text
Get full text

Development of pH-Controlled Aluminum-Based Polymeric Gel for Conformance Control in Sour Gas Reservoirs by Shamlooh M.

“…The results reveal that aluminum acetate, among the screened salts, has a controllable gelation time at pH conditions between 3.5 and 8.5 and is the most stable in the temperature range 25–100 °C. …”
Get full text
Get full text
Get full text

Electrical characteristics and density of states of thin-film transistors based on sol-gel derived ZnO channel layers with different annealing temperatures by Wang S.

Get full text
Get full text

The influence of environmental and core temperature on cyclooxygenase and PGE2 in healthy humans by Esh, Christopher J.

“…Random coefficient models determined relationships between Tc and COX/PGE2. Tc [mean (range)] increased in hot [+ 0.8 (0.4–1.2) °C; p < 0.0001; effect size (ES): 2.9], decreased in cold [− 0.5 (− 0.8 to − 0.2) °C; p < 0.0001; ES 2.6] and was unchanged in thermoneutral [+ 0.1 (− 0.2 to 0.4) °C; p = 0.3502]. …”
Get full text
Get full text
Get full text