Effect of Fluid Viscosity and Fiber Length on the Performance of Fibrous Fluid in Horizontal Well Cleanout by Mendez, Michael

“…When a small amount (0.04% wt.) of long fiber was added, the cleanout performance of the high-viscosity fluid did not show a noticeable change. …”
Get full text
Get full text

Development And Performance Evaluation Of Smart Polymeric Coatings For Corrosion Protection Of Steel by Khan, Adnan

“…Most common cause of materials and equipment failure in the oil and gas industry is corrosion. According to one survey, about 1/4 to 1/3 of the total downtime in plants is due to deleterious effects of corrosion. …”
Get full text

Influence of adhesive thickness and filler content on the mechanical performance of aluminum single-lap joints bonded with aluminum powder filled epoxy adhesive by Kahraman, R.

Get full text
Get full text

Phase change materials based on high-density polyethylene filled with microencapsulated paraffin wax by Krupa, Igor

Get full text
Get full text

Changes In Biomass Gain, Protein Content And Hormonal Levels In Wheat Kernels In Response To Soil Drench With Sodium Salicylate by Abo Hamed, S. A.

“…Drenching of soil with sodim salycylate (800,4000 and 8000mg/l) increased grain f. wt. and d. wt. Protein content was increased in grains at days 23 and 60 with 800 mg/1 salicylate. …”
Get full text

Effect of graphene loading on thermomechanical properties of poly(vinyl alcohol)/starch blend by Jose, J.

“…Mechanical properties results showed that the optimum loading of graphene was 0.5 wt % in the blend. XRD studies indicated uniform dispersion of graphene in PVA/starch matrix upto 0.5 wt % loadings and further increase caused agglomeration. …”
Get full text
Get full text

Effect of gamma irradiation on the microstructure and morphology of polyethylene oxide and polyvinyl alcohol blends by Al-Maadeed, M.

“…Thin films of a blend of 90, 75, 50 (wt/wt%) percentage of polyethylene oxide and polyvinyl alcohol were synthesized and irradiated with 5, 25, 50, 100 and 200 kGy. …”
Get full text
Get full text

Effect of Magnetic Baffles and Magnetic Nanofluid on Thermo-Hydraulic Characteristics of Dimple Mini Channel for Thermal Energy Applications by Souayeh, Basma

“…The increment changed to 1.82%, 8.16%, and 22.31% for a pitch = 5 mm and 1.01%, 5.96%, and 21.38% for a pitch = 2.5 mm. …”
Get full text
Get full text
Get full text

Experimental and theoretical studies on the mechanical and structural changes imposed by the variation of clay loading on poly(vinyl alcohol)/cloisite 93A nanocomposites by Kabalan L.

Get full text
Get full text

Modelling of the flow behaviour of wrought aluminium alloys at elevated temperatures by a new constitutive equation by El Mehtedi, M.

“…The calculation indicated that the activation energy for hot working decreased from 218 to 198kJmol−1 in the considered range of strain.…”
Get full text
Get full text
Get full text

Effect of outdoor temperature on the power-conversion efficiency of newly synthesized organic photosensitizer based dye-sensitized solar cells by Mehmood U.

Get full text
Get full text

Reactive Absorption of CO2 Using Ethylaminoethanol Promoted Aqueous Potassium Carbonate Solvent by Bhosale, Rahul Rambhau

“…In this paper, the kinetics of absorption of CO2 into an aqueous K2CO3 (20 wt %) promoted by ethylaminoethanol (EAE) solution (hereafter termed as APCE solvent) was studied in a glass stirred cell reactor using a fall in pressure method. …”
Get full text
Get full text

Propagation rate coefficient for sulfobetaine monomers by PLP-SEC by Lacík, Igor

“…The kp decreases upon increasing the monomer concentration up to 20 wt % followed by independence of kp on further increased monomer concentration. …”
Get full text
Get full text

Investigation of the rheological properties of nanosilica-reinforced polyacrylamide/polyethyleneimine gels for wellbore strengthening at high reservoir temperatures by Shamlooh M.

“…The objective of this work is to investigate the effect of nanosilica sizes (8, 20, 50, and 85 nm) and concentrations (0.1–2 wt %) on the stability and viscoelastic behavior of polyacrylamide (PAM) cross-linked with polyethyleneimine (PEI) at 130 °C. …”
Get full text
Get full text

Synthesis of High-Antifouling and Antibacterial Ultrafiltration Membranes Incorporating Low Concentrations of Graphene Oxide by Alkhouzaam, Abedalkader Ibraheem

“…The pure water permeability (PWP) decreased with loadings of GO from 181.7 L.m-2.h-1.bar-1 of pure PSF to 181.1 and 167.4 L.m-2.h-1.bar-1 with 0.02 and 0.1 wt.% GO respectively. …”
Get full text
Get full text

Foamed phase change materials based on recycled polyethylene/paraffin wax blends by Sobolčiak, Patrik

“…Foamed phase-change materials (FPCMs) were prepared using recycled linear low-density polyethylene (LLDPE) blended with 30 wt.% of paraffin wax (PW) and foamed by 1,1′-azobiscarbamide. …”
Get full text
Get full text

Effect of serum lipoproteins on stereoselective halofantrine metabolism by rat hepatocytes by Patel, J. P.

“…Experimental hyperlipidemia has shown to decrease cytochrome P450 3A4 and 2C11 expression and to increase liver concentrations and the plasma protein binding of halofantrine (HF) enantiomers. …”
Get full text
Get full text

Anti-Neoplastic Effects of Annonacin against Renal Cell Carcinoma by Munusamy, Shankar

“…Results: hour annonacin treatment caused a significant and dose-dependent decrease in the viability of CaKi-2 cells, i.e., 42% in 0.5 ?…”
Get full text
Get full text

Artificial weathering and accelerated heat aging studies on low-density polyethylene (Ldpe) produced via autoclave and tubular process technologies by Luyt, A. S.

Get full text
Get full text

Investigating the effect of polymer-modified graphene oxide coating on RO membrane fouling by Ashfaq, Mohammad Y.

“…The membrane surface characterization showed a decrease in membrane surface roughness from 74.7 nm to 69.0 nm and an increase in membrane hydrophilicity as the contact angle decreased from 41.7 ± 4.50 to 22.0 ± 1.10. …”
Get full text
Get full text