Knockdown of ATP2C1 results in a minor decrease of [Ca²⁺] in WPB. by Julian Terglane (12975565)

Creep failure mode and sketch map of step-step fractured rock. by Dengke Yang (842532)

The motor torque curves of load increase/decrease (A) the load of 10 N • m (B) the load of 20 N • m. by Taochang Li (20642935)

“…<p>The motor torque curves of load increase/decrease (A) the load of 10 N • m (B) the load of 20 N • m.…”

The motor speed curves of load increase/decrease (A) the load of 10 N • m (B) the load of 20 N • m. by Taochang Li (20642935)

“…<p>The motor speed curves of load increase/decrease (A) the load of 10 N • m (B) the load of 20 N • m.…”

Effective contact rate over time for the different modelling scenarios considered: fixed, continuously increasing, continuously decreasing and with a step-decrease. by Joshua Looker (21390948)

“…<p>Effective contact rate over time for the different modelling scenarios considered: fixed, continuously increasing, continuously decreasing and with a step-decrease.</p>…”

Extensive loading of WPB with the synthetic MaPCa Ca²⁺-Indicators affects WPB size. by Julian Terglane (12975565)

Creep failure mode and sketch map of slow-step fractured rock. by Dengke Yang (842532)

Disturbance of coherent behaviour leads to a decrease in information transfer. by Hannah Zoller (19688084)

Fig 9(b) in the straight-line fitting results. by Zhezhe Zhang (19704587)

“…Therefore, it can be inferred that the decrease in cohesion caused by normal unloading is the main reason for the decrease in joint instability shear strength. …”

Flow diagram illustrating the sequence of procedures executed during one time step defined as tick, each of which represents one week. by Alexandra M. Campbell (3284094)

Subjects:

Error analysis. (a) Location-1 loading. (b) Location-2 loading. by Changxi Shan (22493205)

LBM-based approach using synchronous transformation with a time step of 0.43s, PNGM-based method using asynchronous transformation with a 5s time step, VGA using explicit scheme wi... by Mouad Klai (20818364)

Cancer virtual patients with decreased initial neutrophil concentrations have higher viral load peaks. by Sonia T. Gazeau (21512764)

“…<b>B)</b> Sensitivity analysis determined that decreasing <i>N</i>0 (the initial concentration of neutrophils) causes higher peak viral load and peak IL-6 and IFN concentrations.…”

Relationships between total energy(a), pre-peak energy(b), post-peak energy(c) and loading rates. by Hanqiu Wang (13204812)

Includes a file with the results on step parameters. by Sanne Ettema (18786312)

Picture representing real-time visual feedback for wide step width. by Fateme Khorramroo (18086501)

Correlation between match load and wellness on MD+2. by Ivan Baptista (5278874)

Subjects:

Correlation between match load and wellness on MD+1. by Ivan Baptista (5278874)

Subjects:

Comparison of diffusion simulations: implicit scheme of the GDE with a 30-second time step (blue line), implicit scheme of the PNGM with α = 0.6 and a 15-second time step (green li... by Mouad Klai (20818364)

Table of step height. by Jianbo Jia (717814)

“…The simulation results show that for steps of 1mm, 2mm and 3mm height, the optimal polyline angle is concentrated in the range of 10°-11°, in which the Angle of 10.5° has a good performance against the steps of three heights. …”