Search alternatives:
significant mass » significant main (Expand Search), significant male (Expand Search), significant cause (Expand Search)
point decrease » point increase (Expand Search)
mass increased » cases increased (Expand Search), causes increased (Expand Search), costs increased (Expand Search)
non decrease » nn decrease (Expand Search), note decreased (Expand Search), fold decrease (Expand Search)
significant mass » significant main (Expand Search), significant male (Expand Search), significant cause (Expand Search)
point decrease » point increase (Expand Search)
mass increased » cases increased (Expand Search), causes increased (Expand Search), costs increased (Expand Search)
non decrease » nn decrease (Expand Search), note decreased (Expand Search), fold decrease (Expand Search)
-
1
-
2
-
3
-
4
-
5
-
6
-
7
-
8
Table1_Exposure to Roundup increases movement speed and decreases body mass in earthworms.docx
Published 2022“…Exposure to this contaminant drove a decrease in body mass and increase in movement, which outside of the lab might increase the speed of tunnel formation and microbial dispersal, at a cost to the earthworms. …”
-
9
-
10
Significantly variable serum polyunsaturated fatty acid metabolites.
Published 2024“…Non-significant comparisons are hidden.</p>…”
-
11
-
12
-
13
Downregulation of DOM decreases the abundance of PER and TIM.
Published 2019“…Error bars represent ± SEM; n.s., non significant,*<i>P</i> < 0.05,**p < 0.01, ***p < 0.001, one-way ANOVA. …”
-
14
-
15
AMPs are increased in lesional HS, but DCD and other sweat-gland associated proteins are decreased.
Published 2019“…Genes represented in orange were unchanged (FC < 2, p-adj < 0.05) in HS lesional vs. HS non-lesional skin. Non-adjusted p-values were used for generation of the volcano plot to minimize points with tied y-values but significance level was set using the corresponding non-adjusted p-values. …”
-
16
-
17
Effects on cooling air mass flow rate.
Published 2025“…The results reveal that the large deviation in the manufactured vane (up to 0.5 mm at the leading edge) alters the direction of the coolant flowing out from the leading-edge film-cooling holes, affects the film coverage along the surface, and in consequence, causes the temperature near the stagnation point increasing by approximately 40 K. Furthermore, variations in coolant inlet pressure, decreasing by 10 kPa, and temperature, increasing by 10 K, result in the vane surface temperature increased by 20 ~ 30 K. …”
-
18
Layout of plane measurement points at three different heights and the vicinity of the source area.
Published 2024Subjects: -
19
-
20