Search alternatives:
increase decrease » increased release (Expand Search), increased crash (Expand Search)
side decrease » sizes decrease (Expand Search), fid decreased (Expand Search), step decrease (Expand Search)
a decrease » _ decrease (Expand Search), _ decreased (Expand Search), _ decreases (Expand Search)
increase decrease » increased release (Expand Search), increased crash (Expand Search)
side decrease » sizes decrease (Expand Search), fid decreased (Expand Search), step decrease (Expand Search)
a decrease » _ decrease (Expand Search), _ decreased (Expand Search), _ decreases (Expand Search)
-
2441
-
2442
-
2443
-
2444
-
2445
Combination of intraperitoneal and intratumoral administration of vitamin D3 is more effective in reducing the EAC tumor volume compared to just i.p. administration:
Published 2025“…Among the vitamin D3 groups (i.p and i.p & i.t) it was observed that there was a significant increase in the p53 expression in i.p & i.t combination compared to i.p. alone. …”
-
2446
Baseline characteristics of the participants.
Published 2025“…</p><p>Results</p><p>After finerenone treatment, the levels of UACR, urinary β2-microglobulin (β2-MG) and proinflammatory cytokines in patients decreased compared with the pretreatment levels. Moreover, the rates of decrease in the UACR levels in the macroalbuminuria group were significantly greater than those in the microalbuminuria group. …”
-
2447
-
2448
-
2449
-
2450
-
2451
Mechanical parameter trends under different chemical environments and wet-dry cycles.
Published 2024Subjects: -
2452
Patterns of energy changes in marble samples and their stress-strain curves under dry-wet cycles.
Published 2024Subjects: -
2453
Data cleaning and preparation algorithm.
Published 2025“…</p><p>Conclusions</p><p>Liver cancer morbidity and mortality rates have risen in Kazakhstan over the past decade, with a slight decrease during the early COVID-19 pandemic. …”
-
2454
-
2455
-
2456
-
2457
Comparison with Existing Studies.
Published 2025“…The results indicate that: (1) the presence of pores prolongs both the time to failure and the onset of the AE burst stage, with longer durations observed at higher pore dip angles; (2) AE signal amplitude and frequency vary significantly across different loading stages, and the b-value exhibits an “increase–fluctuation–decrease” trend, with the decreasing stage serving as a precursor to rock instability; (3) pore dip angle strongly influences crack propagation types: dip angles of 0°–30° favor axial cracks and through-going wing cracks, 45°–75° angles tend to induce co-planar and wing crack connectivity, while 90° angles cause crack deviation, hindering through-going failure; (4) intact rock fails in a tensile–shear mixed mode, whereas the number of shear cracks in rocks with pores initially increases and then decreases with dip angle, reaching a maximum at 45°, resulting in shear-dominated failure. …”
-
2458
Specimen Preparation and Experimental Setup.
Published 2025“…The results indicate that: (1) the presence of pores prolongs both the time to failure and the onset of the AE burst stage, with longer durations observed at higher pore dip angles; (2) AE signal amplitude and frequency vary significantly across different loading stages, and the b-value exhibits an “increase–fluctuation–decrease” trend, with the decreasing stage serving as a precursor to rock instability; (3) pore dip angle strongly influences crack propagation types: dip angles of 0°–30° favor axial cracks and through-going wing cracks, 45°–75° angles tend to induce co-planar and wing crack connectivity, while 90° angles cause crack deviation, hindering through-going failure; (4) intact rock fails in a tensile–shear mixed mode, whereas the number of shear cracks in rocks with pores initially increases and then decreases with dip angle, reaching a maximum at 45°, resulting in shear-dominated failure. …”
-
2459
UCS texts data.
Published 2025“…The results indicate that: (1) the presence of pores prolongs both the time to failure and the onset of the AE burst stage, with longer durations observed at higher pore dip angles; (2) AE signal amplitude and frequency vary significantly across different loading stages, and the b-value exhibits an “increase–fluctuation–decrease” trend, with the decreasing stage serving as a precursor to rock instability; (3) pore dip angle strongly influences crack propagation types: dip angles of 0°–30° favor axial cracks and through-going wing cracks, 45°–75° angles tend to induce co-planar and wing crack connectivity, while 90° angles cause crack deviation, hindering through-going failure; (4) intact rock fails in a tensile–shear mixed mode, whereas the number of shear cracks in rocks with pores initially increases and then decreases with dip angle, reaching a maximum at 45°, resulting in shear-dominated failure. …”
-
2460