Raw data underlying the quantitative results reported in the manuscript. by Lai Jiang (2401513)

Subjects:

Trends of average respiratory symptom scores during the post-challenge period. by Oumayma Arbani (21001472)

Subjects:

Promotion of CO₂ Reactivity by Organic Acid on Aerosol Surfaces by Hao Li (31608)

Subjects:

The original plotting data. by Hongmei Qian (538647)

Subjects:

Association between workability and laboratory findings of diabetic workers. by Sarah A. Bolbol (21702891)

Subjects:

Construction of transgenic <i>D</i>. <i>parva</i> overexpressing <i>DpAP2</i> gene. by Lingru Ruan (18995544)

Subjects:

Fig 4 - by Lingru Ruan (18995544)

Subjects:

Overexpression <i>TRIM37</i> inhibits inflammatory infiltration and alleviates demyelination in EAE model mice. by Lai Jiang (2401513)

Subjects:

Quantitative estimation of viral concentration from qRT-PCR data using a regression equation. by Oumayma Arbani (21001472)

Subjects:

Sociodemographic, occupational, and clinical risk factors associated with low workability and results of Logistic regression analysis among diabetic workers. by Sarah A. Bolbol (21702891)

Subjects:

Carotenoid contents of control and transgenic <i>D</i>. <i>parva</i>. by Lingru Ruan (18995544)

Subjects:

Association between workability and clinical characteristics of diabetic workers. by Sarah A. Bolbol (21702891)

Subjects:

Quantitative proteomic analysis of Δ<i>pbpp6</i> and WT <i>P. berghei</i> gametocytes. by Yonghui Feng (12227596)

Phenotype analysis of PbPP6-GFP parasites. by Yonghui Feng (12227596)

Bar charts showing the numbers of significantly differentially expressed genes for the different contrasts. by Gillian P. McHugo (8965919)

“…<p>The extent of the bar above and below 0 on the vertical axis indicates the numbers of significantly differentially expressed genes (DEGs; B-H <i><i>P</i></i><sub>adj.…”

Comparison with Existing Studies. by Na Zhao (112953)

“…The results indicate that: (1) the presence of pores prolongs both the time to failure and the onset of the AE burst stage, with longer durations observed at higher pore dip angles; (2) AE signal amplitude and frequency vary significantly across different loading stages, and the b-value exhibits an “increase–fluctuation–decrease” trend, with the decreasing stage serving as a precursor to rock instability; (3) pore dip angle strongly influences crack propagation types: dip angles of 0°–30° favor axial cracks and through-going wing cracks, 45°–75° angles tend to induce co-planar and wing crack connectivity, while 90° angles cause crack deviation, hindering through-going failure; (4) intact rock fails in a tensile–shear mixed mode, whereas the number of shear cracks in rocks with pores initially increases and then decreases with dip angle, reaching a maximum at 45°, resulting in shear-dominated failure. …”

Specimen Preparation and Experimental Setup. by Na Zhao (112953)

“…The results indicate that: (1) the presence of pores prolongs both the time to failure and the onset of the AE burst stage, with longer durations observed at higher pore dip angles; (2) AE signal amplitude and frequency vary significantly across different loading stages, and the b-value exhibits an “increase–fluctuation–decrease” trend, with the decreasing stage serving as a precursor to rock instability; (3) pore dip angle strongly influences crack propagation types: dip angles of 0°–30° favor axial cracks and through-going wing cracks, 45°–75° angles tend to induce co-planar and wing crack connectivity, while 90° angles cause crack deviation, hindering through-going failure; (4) intact rock fails in a tensile–shear mixed mode, whereas the number of shear cracks in rocks with pores initially increases and then decreases with dip angle, reaching a maximum at 45°, resulting in shear-dominated failure. …”

UCS texts data. by Na Zhao (112953)

“…The results indicate that: (1) the presence of pores prolongs both the time to failure and the onset of the AE burst stage, with longer durations observed at higher pore dip angles; (2) AE signal amplitude and frequency vary significantly across different loading stages, and the b-value exhibits an “increase–fluctuation–decrease” trend, with the decreasing stage serving as a precursor to rock instability; (3) pore dip angle strongly influences crack propagation types: dip angles of 0°–30° favor axial cracks and through-going wing cracks, 45°–75° angles tend to induce co-planar and wing crack connectivity, while 90° angles cause crack deviation, hindering through-going failure; (4) intact rock fails in a tensile–shear mixed mode, whereas the number of shear cracks in rocks with pores initially increases and then decreases with dip angle, reaching a maximum at 45°, resulting in shear-dominated failure. …”

S1 File - by Ingmar Lundquist (46422)

“…Additionally, the significance of extracellular NO on GSIS was studied. …”

Transcriptome analysis of Δ<i>pbpp6</i> and WT <i>P. berghei</i> gametocytes. by Yonghui Feng (12227596)