Digital Microfluidic Platform Based on Printed Circuit Board for Affinity Evaluation of Mertansine Aptamers by Dongliu Xiang (10688647)

“…Compared with manual methods, the digital microfluidic platform not only reduced the time for a single determination from 105 to 45 min but also significantly decreased the reagent consumption from 1280 to 30.72 μL. …”

Amorphous Silica/NaNbO₃ Crystal Heterophase Junction-Supported Ru Catalyst with Optimized Surface and Electron Structure for Highly Efficient Hydrogenation of α‑Pinene... by Haozhang Xu (21366415)

“…Optimizing supported catalysts through support improvement is a feasible approach to balance effectiveness and cost. …”

Task design for measurement of pupillary response. by Tomoe Hayakawa (20978784)

Standardized estimation of centrality index. by Song Chen (69646)

“…Furthermore, there was a noticeable decrease in the correlation between depressive symptoms and a reduced stability in the network structure during periods of high physical activity compared to those of low physical activity (88.9% → 66.7%, 80.5% → 72.2%). …”

Kaplan-Meier survival analysis curves according to the APTT levels between four groups. by Huan Wang (109286)

Confirmation of NMIIC expression. by Hiroki Hamaguchi (22783780)

All data from the experiment. by Kazufumi Hisamoto (21416905)

“…Therefore, we aimed to investigate whether mild hyperbaric hyperoxia enhances aerobic capacity and decreases cardiopulmonary stress during exercise with a particular focus on the ventilatory threshold (VT). …”

The protocol of the maximal cycle-ergometer test. by Kazufumi Hisamoto (21416905)

“…Therefore, we aimed to investigate whether mild hyperbaric hyperoxia enhances aerobic capacity and decreases cardiopulmonary stress during exercise with a particular focus on the ventilatory threshold (VT). …”

Impact of sludge dosage on HPST. by Peng Zhao (128233)

“…The model optimization and experimental validation showed that the optimal HPST conditions for treating domestic sewage were as follows: the dosage of polyaluminum chloride (PAC) was 1.70 g/L, cationic polyacrylamide (CPAM) dosage was 2.35 mg/L, sewage pH was maintained at 8.0, sludge dosage was 10 mL/L, stirring time lasted for 5 minutes, and settling time lasted for 30 minutes. As a result of these optimized conditions, the turbidity of treated sewage decreased to 1.19 NTU.…”

Impact of settling time on HPST. by Peng Zhao (128233)

“…The model optimization and experimental validation showed that the optimal HPST conditions for treating domestic sewage were as follows: the dosage of polyaluminum chloride (PAC) was 1.70 g/L, cationic polyacrylamide (CPAM) dosage was 2.35 mg/L, sewage pH was maintained at 8.0, sludge dosage was 10 mL/L, stirring time lasted for 5 minutes, and settling time lasted for 30 minutes. As a result of these optimized conditions, the turbidity of treated sewage decreased to 1.19 NTU.…”

ANOVAs for the response surface of Eq (2). by Peng Zhao (128233)

“…The model optimization and experimental validation showed that the optimal HPST conditions for treating domestic sewage were as follows: the dosage of polyaluminum chloride (PAC) was 1.70 g/L, cationic polyacrylamide (CPAM) dosage was 2.35 mg/L, sewage pH was maintained at 8.0, sludge dosage was 10 mL/L, stirring time lasted for 5 minutes, and settling time lasted for 30 minutes. As a result of these optimized conditions, the turbidity of treated sewage decreased to 1.19 NTU.…”

Impact of CPAM dosage on HPST. by Peng Zhao (128233)

“…The model optimization and experimental validation showed that the optimal HPST conditions for treating domestic sewage were as follows: the dosage of polyaluminum chloride (PAC) was 1.70 g/L, cationic polyacrylamide (CPAM) dosage was 2.35 mg/L, sewage pH was maintained at 8.0, sludge dosage was 10 mL/L, stirring time lasted for 5 minutes, and settling time lasted for 30 minutes. As a result of these optimized conditions, the turbidity of treated sewage decreased to 1.19 NTU.…”

Impact of sewage pH on HPST. by Peng Zhao (128233)

“…The model optimization and experimental validation showed that the optimal HPST conditions for treating domestic sewage were as follows: the dosage of polyaluminum chloride (PAC) was 1.70 g/L, cationic polyacrylamide (CPAM) dosage was 2.35 mg/L, sewage pH was maintained at 8.0, sludge dosage was 10 mL/L, stirring time lasted for 5 minutes, and settling time lasted for 30 minutes. As a result of these optimized conditions, the turbidity of treated sewage decreased to 1.19 NTU.…”

Impact of PAC dosage on HPST. by Peng Zhao (128233)

“…The model optimization and experimental validation showed that the optimal HPST conditions for treating domestic sewage were as follows: the dosage of polyaluminum chloride (PAC) was 1.70 g/L, cationic polyacrylamide (CPAM) dosage was 2.35 mg/L, sewage pH was maintained at 8.0, sludge dosage was 10 mL/L, stirring time lasted for 5 minutes, and settling time lasted for 30 minutes. As a result of these optimized conditions, the turbidity of treated sewage decreased to 1.19 NTU.…”

All data points from S1 to S5 Figs as well as the supplementary method table. by Sara Hijazi (21656615)

The ROC curves and AUC values of the diagnostic model. by Zhe Wu (582498)

Limma differential analysis results for IS and OSA. by Zhe Wu (582498)

Co-expression network of IS and OSA. by Zhe Wu (582498)

Histopathological appearance of the liver. by Ayça Toprak-Semiz (22582110)

Effect of KV3 modulation on PV interneuron firing frequency and on autaptic release. by Sara Hijazi (21656615)