Variation of T₂ spectrum of 0.38 water–binder ratio of concrete during F–T process under standard curing conditions: (a) Air content = 1.5%; (b) Air content = 3.6%; (c)... by YongHe Liu (20477123)

Subjects:

Comparison with Existing Studies. by Na Zhao (112953)

“…The results indicate that: (1) the presence of pores prolongs both the time to failure and the onset of the AE burst stage, with longer durations observed at higher pore dip angles; (2) AE signal amplitude and frequency vary significantly across different loading stages, and the b-value exhibits an “increase–fluctuation–decrease” trend, with the decreasing stage serving as a precursor to rock instability; (3) pore dip angle strongly influences crack propagation types: dip angles of 0°–30° favor axial cracks and through-going wing cracks, 45°–75° angles tend to induce co-planar and wing crack connectivity, while 90° angles cause crack deviation, hindering through-going failure; (4) intact rock fails in a tensile–shear mixed mode, whereas the number of shear cracks in rocks with pores initially increases and then decreases with dip angle, reaching a maximum at 45°, resulting in shear-dominated failure. …”

Specimen Preparation and Experimental Setup. by Na Zhao (112953)

“…The results indicate that: (1) the presence of pores prolongs both the time to failure and the onset of the AE burst stage, with longer durations observed at higher pore dip angles; (2) AE signal amplitude and frequency vary significantly across different loading stages, and the b-value exhibits an “increase–fluctuation–decrease” trend, with the decreasing stage serving as a precursor to rock instability; (3) pore dip angle strongly influences crack propagation types: dip angles of 0°–30° favor axial cracks and through-going wing cracks, 45°–75° angles tend to induce co-planar and wing crack connectivity, while 90° angles cause crack deviation, hindering through-going failure; (4) intact rock fails in a tensile–shear mixed mode, whereas the number of shear cracks in rocks with pores initially increases and then decreases with dip angle, reaching a maximum at 45°, resulting in shear-dominated failure. …”

UCS texts data. by Na Zhao (112953)

“…The results indicate that: (1) the presence of pores prolongs both the time to failure and the onset of the AE burst stage, with longer durations observed at higher pore dip angles; (2) AE signal amplitude and frequency vary significantly across different loading stages, and the b-value exhibits an “increase–fluctuation–decrease” trend, with the decreasing stage serving as a precursor to rock instability; (3) pore dip angle strongly influences crack propagation types: dip angles of 0°–30° favor axial cracks and through-going wing cracks, 45°–75° angles tend to induce co-planar and wing crack connectivity, while 90° angles cause crack deviation, hindering through-going failure; (4) intact rock fails in a tensile–shear mixed mode, whereas the number of shear cracks in rocks with pores initially increases and then decreases with dip angle, reaching a maximum at 45°, resulting in shear-dominated failure. …”

Prescription data. by Dainty Ei (22265317)

Subjects:

SBP3 KD decreases the surface localization of VESA-1. by Atefeh Fathi (7370876)

EGF is decreased in individual donor milk, but not pooled donor milk. by Christian Tamar (21100605)

<i>SLC2A2</i> is associated with IGF1R pathways differentiation. by Yejin Kim (740789)

Subjects:

Changes in <i>SLC2A2</i> gene expression in hepatocellular carcinoma (HCC) based on its stage and correlation with oncofetal and stemness genes. by Yejin Kim (740789)

Subjects:

Primers used for qPCR gene expression analysis. by Yejin Kim (740789)

Subjects:

The IGF1R pathway is upregulated following <i>slc2a2</i> knockdown in HepG2 cells and zebrafish embryos. by Yejin Kim (740789)

Subjects:

Gene expression dynamics during liver development. by Yejin Kim (740789)

Subjects:

Protein levels of GLUT2 were analyzed by western blotting. by Yejin Kim (740789)

Subjects:

Variation of T₂ spectrum of 0.38 water–binder ratio of concrete during F–T process under −3 °C curing conditions: (a) Air content = 1.5%; (b) Air content = 3.6%; (c) Air... by YongHe Liu (20477123)

Subjects:

Variation of T₂ spectrum of 0.38 water–binder ratio of concrete during F–T process under 5 °C curing conditions: (a) Air content = 1.5%; (b) Air content = 3.6%; (c) Air... by YongHe Liu (20477123)

Subjects:

A prepubertal CD decreases hepatic DNA methylation and increases hydroxymethylation in adulthood despite a chronic HFD in Sprague-Dawley male rats. by Ana Aguilar-Lozano (20614619)

Effect of busulfan treatment on the tight junction protein, occludin. by Lingjun Zhao (21763122)

Subjects:

<i>Aspergillus flavus</i> mRNA expression (a) <i>aflD</i> and (c) <i>aflR</i> and phylogenetic analysis of (b) <i>aflD</i> and (d) <i>aflR</i> after exposure to 50 mg/mL of <i>U. e... by Martha Cebile Jobe (21175426)

iKIR score decreases protection associated with protective class II genotypes in T1D. by Laura Mora-Bitria (20477525)

<i>Aedes aegypti</i> database from SAGO traps. by Jesús A. Aguilar-Durán (9931967)

“…IVM treatment reduced the number of females per trap per week from 3.29 ± 0.24 to 2.41 ± 0.20 (33.7% reduction), AGO from 1.58 ± 0.17 to 0.25 ± 0.05 (85.2% reduction), and AGO + IVM from 1.49 ± 0.17 to 0.53 ± 0.08 (67.78% reduction), based on Henderson’s formula. We observed a non-significant increase in the control area (no treatment provided) in the mosquito populations, increasing from 2.94 ± 0.24 in the pretreatment period to 3.25 ± 0.28 of the post treatment period.…”